Uwe

Been here? http://wiki.ross-tech.com/wiki/index.php/18438/P2006/008198 http://wiki.ross-tech.com/wiki/index.php/18447/P2015/008213 -Uwe-

Hello, There is not much information on this fault code, P1736. It is possible there is a concern with the mechatronics unit, I would...

Yep. Put the car in jack mode, get ALL FOUR WHEELS off the ground, then crack open one line at a time at the valve block (not at the...

Please post an Auto-Scan for context. -Uwe-

Yeah, IDE01471-ENG98502 looks like bogus data (i.e. no sensor installed) to me. It sounds like the compressor (or the N280 inside it)...

Alright, i guess i overestimated the speed of resolution on this site. for those who are interested, two things; 1- 30347 is not the...

Are there any lights that aren't working? That module does have Selective Output Tests for all the exterior lights it control...

Hello, Given the information you have provided, I would have to say the sensor is located in the exhaust, third sensor downstream of...

Conditions are not correct because you have a hard fault in the suspension controller. That fault is saying your valve block is faulty...

Hello, I do not think there is any information out there in the public's hands that would help determine what these values actually...

Superficially, yes. But at one point Dana posted a map from Boris (her 2017 VR6 T'reg, since traded away) and.... So I suspect that's...

Simply look what is shown / listed (faults) for Address 02 Auto-Trans. Those are the faults the system does not like ; the sympathy...

"TCM" means the transmission itself, module 02. Every error that says "Check TCM for errors too!" is just a sympathy code as @Uwe...

Hi and welcome. I have a fuzzy recollection that there are some Westfalia trailer modules that don't talk to a scan tool. But please...

Brake electronics is protected by SFD, so not possible with VCDS at this time.