Latest activity

There *might* be someone who makes an aftermarket version of the correct faceplate in MPH. There may be a suitable VW one, but I'd be a...

It was bought at an car auction so bought as seen

@jyoung8607 I sent you a message, I just joined this forum and stumbled on this thread. Trying to figure a few things out and didn't...

Here is the picture of the item I purchased. https://photos.app.goo.gl/Zxdin4TFLENbLtth9

No change, fault reappears immediately after clearing.

So is there a way to change the SW or maybe calibrate based on the Lambo specs similar to an S5? Do you know what the coding would be...

You're conflating Hardware and software part numbers. The module you're having trouble with is: Software: 470 907 441 (Lambo)...

Hello, While driving gearbox goes into limp mode especially when hot and no reverse. Only when vehicle cools down DSG selects and...

When I search the forums I don't see anyone with that HW model. I see this one for a Q7 model but they are not on Q7s. Was there a bug...

When what you may have to do is break out the DMM, set it to beep beep beep and start wiggle testing the wiring and see if you can find...

Yes. Most likely, yes. I don't think the ECU is willing to show that to a scan tool. I believe all it will give you is manifold...

Ohm spec for the camshaft adjuster valves is 12 to 20Ω at 20C... so technically, replace it. But before you do that, 0n bank 2, swap...

It's intermittent works at time then it don't work

Yes. The dealer told me that was the part number and also when I pulled out the old one it was also the same. I checked to make sure...

Are you certain that the old module was HW 8F0 907 441? Because every scan I can find with that hardware part number is in a Lambo...