So I read about dpf regeneration (cleaning) on wiki.ross-tech
And I read this sentence
*Particle Filter Load below Specification (see MVB 108.2/3 -or- 241.2/3 VCDS should give the specified values)*
But some cars using uds protocol has no meas.blocks and I have to use advance measure block but I don't know which boxes I have to check to see load specs
Is it soot measure and soot calculated?
And I read this sentence
*Particle Filter Load below Specification (see MVB 108.2/3 -or- 241.2/3 VCDS should give the specified values)*
But some cars using uds protocol has no meas.blocks and I have to use advance measure block but I don't know which boxes I have to check to see load specs
Is it soot measure and soot calculated?