Hello,
I’ve had my VCDS a few days and have done a few scans on our vehicles, 1 x 2014 Skoda Octavia and 1 x 2005 VW Passat 1.9 TDI.
I have saved the initial auto scans from both vehicles, and do this each time I run VCDS and run a scan before looking at anything else, I hope this is good practice?
I have recently carried out a Haldex service, removing the pump and cleaning everything out, new ‘o’ rings and drain and fill plugs, and new oil.
There are no AWD fault codes in -22 AWD.
I was hoping to do a relearn on the pump motor, after cleaning with VCDS, but was met with the following error message.
Error: conditions not correct or request sequence error.
I will try and post more info when I get to my laptop again, including full scan file, apologies.
Any guidance appreciated,
Thanks
Jason
I’ve had my VCDS a few days and have done a few scans on our vehicles, 1 x 2014 Skoda Octavia and 1 x 2005 VW Passat 1.9 TDI.
I have saved the initial auto scans from both vehicles, and do this each time I run VCDS and run a scan before looking at anything else, I hope this is good practice?
I have recently carried out a Haldex service, removing the pump and cleaning everything out, new ‘o’ rings and drain and fill plugs, and new oil.
There are no AWD fault codes in -22 AWD.
I was hoping to do a relearn on the pump motor, after cleaning with VCDS, but was met with the following error message.
Error: conditions not correct or request sequence error.
I will try and post more info when I get to my laptop again, including full scan file, apologies.
Any guidance appreciated,
Thanks
Jason