Greetings,
Yesterday I had in a 2013 Audi A4 2.0L that was tripping for fuel rail too high. When looking at the data parameters, the high pressure desired read in MPa, while the actual read in kPa. Is there a way to change the unit settings so they both read the same so when graphing the data both are visable instead of going off the chart? Or maybe there is a way to change the graph settings to accept the high number as displayed in kPa.
Thanks.
Yesterday I had in a 2013 Audi A4 2.0L that was tripping for fuel rail too high. When looking at the data parameters, the high pressure desired read in MPa, while the actual read in kPa. Is there a way to change the unit settings so they both read the same so when graphing the data both are visable instead of going off the chart? Or maybe there is a way to change the graph settings to accept the high number as displayed in kPa.
Thanks.