ECS traction control retrofit on jetta mk6

Hello. I have a 2014 Jetta 1.4TSI twincharge engine with 7speed dq200. I'm from Asia.

My car vin number is PPVZZZ16ZEL002385

I have just recently purchased traction control button without keyless start part number (ES#2660876).

I have installed it according to the installation instruction and followed the coding. It works fine. But right now is only able to switch off the ASR but not ESC/ESP. I have tried holding the button 3-5seconds but nothing happen.

I been searching around and there seems to be more coding needed.

This is my original ABS module long coding
A63B60F8212200FC650E06EC841E0080A1100010

I have switch to
A63B60F8212200FC650E06EC841E0080A1180020

Can I know what other coding is required to be able to fully turn off the ESC/ESP.


here is my auto scan
Address 03: ABS Brakes (J104) Labels:. 1K0-907-379-60EC1F.clb
Part No SW: 1K0 907 379 BM HW: 1K0 907 379 BM
Component: ESP MK60EC1 H46 0164
Revision: 00H46001
Coding: A63B60F8212200FC650E06EC841E0080A1100010
Shop #: WSC 83300 833 00006
VCID: 7EF3E6ABE9CB3CB6E3-802A

Would appreciate your help. thank you.

I installed TPMS + ASR OFF on my jetta 1.4t 2016

This is scan of module 3

Address 03: ABS Brakes (J104) Labels:. 1K0-907-379-60EC1F.clb
Part No SW: 1K0 907 379 CC HW: 1K0 907 379 CC
Component: ESP MK60EC1 H46 0175
Revision: 00H46001
Coding: A43B40F8092500FB250C02E6901D004125180033 (this is enable functions)

Hi, I've done that coding on serveral Jetta GLI's with the "379 BM" module.

It seems that byte 19 bits 4,5,6 set to 1 should enable the long press to ESC OFF. You might need to code that byte manually as there's no long coding helper for it.

BITS::: 7 6 5 4 3 2 1 0
VALUE: 0 1 1 1 0 0 0 0

After modifying the bits just go to another byte for VCDS to take tha change, prior to pressing ESC to close the Long Coding Helper.

Hope it works!