I have been trying to diagnose the cruise control on a 2006 Jetta TDI.
All of the switches work in VCDS.
The brake and clutch switch also work.
The running lights are all working and so are the brake lights.
I checked the cruise in VCDS on our two other cars. The cruise does work on these cars.
2005 Passat TDI
2004 Jetta Wagon TDI
This is the only thing that I found was in Cruise Control Switch Monitoring.
With the car on (engine off) and the cruise switched on, this is what our two other cars were.
00000001
This is what the 2006 Jetta TDI was.
10000001
Here is what VCDS says
xxxxxxx1-Stuck ON
xxxxxx1x-Pressed OFF
xxxxx1xx-Decelerate (-)
xxxx1xxx-Accelerate (+)
xxx1xxxx-Set (SET)
xx1xxxxx-Resume (RESET)
1xxxxxxx-Stuck ON (Hardware)
The only codes are Airbag codes.
What does "Stuck ON (Hardware)" mean?
I read that someone fixed a similar problem by replacing the accelerator pedal.
Does that have anything to do with cruise control?
I can get an Auto Scan if you need it.
All of the switches work in VCDS.
The brake and clutch switch also work.
The running lights are all working and so are the brake lights.
I checked the cruise in VCDS on our two other cars. The cruise does work on these cars.
2005 Passat TDI
2004 Jetta Wagon TDI
This is the only thing that I found was in Cruise Control Switch Monitoring.
With the car on (engine off) and the cruise switched on, this is what our two other cars were.
00000001
This is what the 2006 Jetta TDI was.
10000001
Here is what VCDS says
xxxxxxx1-Stuck ON
xxxxxx1x-Pressed OFF
xxxxx1xx-Decelerate (-)
xxxx1xxx-Accelerate (+)
xxx1xxxx-Set (SET)
xx1xxxxx-Resume (RESET)
1xxxxxxx-Stuck ON (Hardware)
The only codes are Airbag codes.
What does "Stuck ON (Hardware)" mean?
I read that someone fixed a similar problem by replacing the accelerator pedal.
Does that have anything to do with cruise control?
I can get an Auto Scan if you need it.