Hello guys!
I've seen this quite a few times, reading up the forum but ... I think it's for the best to just open a new thread.
Unfortunately, every time I try opening the Long Coding Helper, I get the following:
I have to accept the Experimental coding in order to see some parameters, most of them are not correctly translated, or translated at all.
Either way, I found the headlight washer system Bit, checked it, saved it, coding accepted.
Wiring is all done, everything is ok, problem is, BCM is just not triggering the washer system relay (J39) .. ( washer fluid level sensor installed, works fine -- enough fluid in the tank ), holding down the windshield washer for more than 3 seconds, with the headlights on, even engine running, nothing happening.
Connected the relay GND and BCM wire to trigger the switch, works fine, which leaves me with "faulty coding".
Seems like the BCM simply does not want to send current down the washer system wire.
I've sent an Autoscan and the channels admap / measuring values here, at support@rt, last week .. received a confirmation reply.
Any idea ... any other advice ? I'm just trying to split the wire and measure it with a voltmeter, see if there's anything at all flowing through that wire while washing the windscreen.
I'm coming my original post here ( more detailed ): https://uk-polos.net/viewtopic.php?f=56&t=70119&start=30
Please advise .. when can I expect my BCM to be supported by VCDS, given it's around for 3 years now ..
I've seen this quite a few times, reading up the forum but ... I think it's for the best to just open a new thread.
Unfortunately, every time I try opening the Long Coding Helper, I get the following:
I have to accept the Experimental coding in order to see some parameters, most of them are not correctly translated, or translated at all.
Either way, I found the headlight washer system Bit, checked it, saved it, coding accepted.
Wiring is all done, everything is ok, problem is, BCM is just not triggering the washer system relay (J39) .. ( washer fluid level sensor installed, works fine -- enough fluid in the tank ), holding down the windshield washer for more than 3 seconds, with the headlights on, even engine running, nothing happening.
Connected the relay GND and BCM wire to trigger the switch, works fine, which leaves me with "faulty coding".
Seems like the BCM simply does not want to send current down the washer system wire.
I've sent an Autoscan and the channels admap / measuring values here, at support@rt, last week .. received a confirmation reply.
Code:
Saturday,09,September,2017,19:05:08:58812
VCDS -- Windows Based VAG/VAS Emulator Running on Windows 10 x64
VCDS Version: 17.8.0.1 (x64) HEX-V2 CB: 0.4401.4
Data version: 20170721 DS276.2
www.Ross-Tech.com
VIN: WVWZZZ6RZFYXXXXXX License Plate:
Mileage: 28624km-17786mi Repair Order:
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Chassis Type: 6R-VW26 (6C0)
Scan: 01 03 08 09 15 17 19 44 5F
VIN: WVWZZZ6RZFY146290 Mileage: 28624km-17786miles
01-Engine -- Status: OK 0000
03-ABS Brakes -- Status: OK 0000
08-Auto HVAC -- Status: OK 0000
09-Cent. Elect. -- Status: OK 0000
15-Airbags -- Status: OK 0000
17-Instruments -- Status: OK 0000
19-CAN Gateway -- Status: OK 0000
44-Steering Assist -- Status: OK 0000
5F-Information Electr. -- Status: OK 0000
-------------------------------------------------------------------------------
Address 01: Engine (J000-CUSA) Labels:. 04B-907-445-V1.clb
Part No SW: 04B 906 027 HW: 04B 907 445
Component: R3 1,4 DCM6.2 H07 8205
Revision: 21003001
Coding: 01114012432401080000
Shop #: WSC 00788 648 00255
ASAM Dataset: EV_ECM14TDI03004B906027 003019
ROD: EV_ECM14TDI03004B906027B.rod
VCID: 5EE697A3B0B9CE37096-800A
No fault code found.
Readiness: N/A
-------------------------------------------------------------------------------
Address 03: ABS Brakes (J104) Labels:. 6R0-907-37x-ESP90.clb
Part No SW: 6C0 907 379 G HW: 6R0 907 379 BA
Component: ESP9.0i H03 0003
Serial number: 08503245140827
Coding: 21DD2485892733C6091610720051842491CC90080007C9098F00
Shop #: WSC 00788 648 00255
ASAM Dataset: EV_Brake1ESP90iBOSCHPQ26 100018
ROD: EV_Brake1ESP90iBOSCHPQ26.rod
VCID: 333016176BBB335F968-8066
No fault code found.
-------------------------------------------------------------------------------
Address 08: Auto HVAC (J65) Labels:* None
Part No SW: 6C0 819 045 C HW: 6C0 819 045 C
Component: Heizung H02 0103
Serial number: 1405291B-1136
Coding: 201000000000000200
Shop #: WSC 00788 648 00255
ASAM Dataset: EV_HZGManueHMMValeoPQ26 001001
ROD: EV_HZGManueHMMValeoPQ26.rod
VCID: 2708F247AF634FFF3A0-8072
No fault code found.
-------------------------------------------------------------------------------
Address 09: Cent. Elect. (J519) Labels:* None
Part No HW: 6C0 937 089
Component: BCM PQ26 Hi4R H06 0047
Serial number: 009458017422
Coding: 000008404253005B4B844000400F078800005B0251010000000000000000
Shop #: WSC 12345 123 12345
ASAM Dataset: EV_BCMA0 004003
ROD: EV_BCMA0_004_VW26.rod
VCID: 55F4888FC58F0D6F58C-8000
Drivers Door Control Module:
Subsystem 1 - Part No SW: 6R0 959 801 AT HW: 6R0 959 801 AT Labels: 6R0-959-801.CLB
Component: J386__TSG_FT 003 8612
Serial number: KU0KU001091442441673
Coding: 0400A0
Front Passengers Door Control Module:
Subsystem 2 - Part No SW: 6R0 959 802 BE HW: 6R0 959 802 BE Labels: 6R0-959-802.CLB
Component: J387__TSG_BT 003 8612
Serial number: KU0KU003091442468341
Coding: 1400A0
Drivers Door Rear Control Module:
Subsystem 3 - Part No SW: 6R0 959 811 N HW: 6R0 959 811 N
Component: J388__TSG_HL 003 8610
Serial number: KU0KU009091442525731
Coding: 0400A0
Passengers Rear Door Control Module:
Subsystem 4 - Part No SW: 6R0 959 812 N HW: 6R0 959 812 N
Component: J389__TSG_HR 003 8610
Serial number: KU0KU010091442532611
Coding: 1400A0
No fault code found.
-------------------------------------------------------------------------------
Address 15: Airbags (J234) Labels:| 6C0-959-655.clb
Part No SW: 6C0 959 655 A HW: 6C0 959 655 A
Component: VW20Airbag00Z 001 0330
Revision: -------- Serial number: 003LM004MBGD
Coding: 88C0C000000000005C000000000800000000
Shop #: WSC 00788 648 00255
ASAM Dataset: EV_AirbaVW20BPAVW26X 001001
ROD: EV_AirbaVW20BPAVW26X.rod
VCID: 313C1C1F91A7014FE44-8064
Side Sensor Driver Front:
Subsystem 1 - Part No SW: ----------- HW: 410 820 308 14
Component: SideSensor_Df 151 0800
Serial number: 3575H00BB15739C1930N
Coding: 2D2D2D
Side Sensor Passenger Front:
Subsystem 2 - Part No SW: ----------- HW: 410 820 308 14
Component: SideSensor_Pf 151 0800
Serial number: 3585H00062837AA1D2AO
Coding: 2D2D2D
Side Sensor Driver Rear:
Subsystem 3 - Part No SW: ----------- HW: 442 150 609 14
Component: SideSensor_Dr 1CA 0148
Serial number: 3517A00C31725223B22Z
Coding: 2D2D2D
Side Sensor Passenger Rear:
Subsystem 4 - Part No SW: ----------- HW: 442 150 609 14
Component: SideSensor_Pr 1CA 0148
Serial number: 3527A00C31725220B17.
Coding: 2D2D2D
No fault code found.
-------------------------------------------------------------------------------
Address 17: Instruments (J285) Labels:| 5G0-920-XXX-17.clb
Part No SW: 6C0 920 741 A HW: 6C0 920 741 A
Component: KOMBI 211 0290
Coding: 472509002180000800083A001000000000000000
Shop #: WSC 00788 648 00255
ASAM Dataset: EV_DashBoardVDDMQBAB 009040
ROD: EV_DashBoardVDDMQBAB_009_VW26.rod
VCID: 211CEC5FC147B1CF744-8074
No fault code found.
-------------------------------------------------------------------------------
Address 19: CAN Gateway (J533) Labels:| 6C0-909-901-V1.clb
Part No SW: 6C0 909 901 HW: 6C0 937 089
Component: GW MQB A0 H06 0047
Revision: -------- Serial number: 009458017422
Coding: 030100044F0A590071000000000000010001000000000000000000000000
Shop #: WSC 00788 648 00255
ASAM Dataset: EV_GatewA0Lear 001001
ROD: EV_GatewA0Lear_VW26.rod
VCID: 6594B84F95EF9DEFC8C-8030
Multi Function Steering Wheel Control Module:
Subsystem 1 - Part No SW: 6C0 959 442 A HW: 6C0 959 442 A Labels: 3C8-959-537.CLB
Component: E221__MFL-TAT H04 0019
Serial number: 2411422172402137AD1B
Coding: 280000
Battery Monitoring Control Module:
Subsystem 2 - Part No SW: 6C0 915 181 A HW: 6C0 915 181 A
Component: J367-BDM H08 0223
Serial number: 61247G58362821697892
No fault code found.
-------------------------------------------------------------------------------
Address 44: Steering Assist (J792) Labels:| 6Rx-909-144-V2.clb
Part No SW: 6C1 909 144 M HW: 6C1 909 144 D
Component: EPS_TRW_ALow 312 3211
Serial number: PE9J0052
Coding: 0007
Shop #: WSC 00788 648 00255
ASAM Dataset: EV_SteerAssisUDSTRW 011021
ROD: EV_SteerAssisUDSTRW_011.rod
VCID: 323E131394A13A579DE-8066
No fault code found.
-------------------------------------------------------------------------------
Address 5F: Information Electr. (J794) Labels:| 5G0-035-MIB-ENT2.clb
Part No SW: 6C0 035 869 B HW: 6C0 035 869 B
Component: MU-E--ER 820 6220
Serial number: 26081400010666
Coding: 02620000BE00000041110001000000001F0004840000010000
Shop #: WSC 00788 648 00255
ASAM Dataset: EV_MUEnt4CGen2LGE 001017
ROD: EV_MUEnt4CGen2LGE_VW12.rod
VCID: 2A0E0B73BC71729725E-807E
No fault code found.
End----------(Elapsed Time: 00:41, VBatt start/end: 12.1V/12.1V)-----------
Any idea ... any other advice ? I'm just trying to split the wire and measure it with a voltmeter, see if there's anything at all flowing through that wire while washing the windscreen.
I'm coming my original post here ( more detailed ): https://uk-polos.net/viewtopic.php?f=56&t=70119&start=30
Please advise .. when can I expect my BCM to be supported by VCDS, given it's around for 3 years now ..