Hi All,
I've only had my HEX-V2 (3 VIN) and VCDS for 2 days and still not sure if I'm using the software correctly.
My VCDS is registered, validated and updated and as yet I've not been requested to register one of my VIN.
I purchased the cable because a friend advised me that I should have done an adaptations reset and TBA
following a MAF sensor change in February. To be honest the MAF certainly improved the engine performance
but also made the erratic/inconsistent auto gearshifts more noticeable.
I initially tried to do the adaptations on the 02 Auto Trans but that box is greyed out, then tried to do the
adaptations on 01 Engine but only got error messages. I assumed this was due to not having an associated
label file for the engine and have since sent Ross-Tech my control module map files.
My next train of thought was to select basic settings for both engine and auto transmission but once again these
boxes are greyed out.
Any help or advice would be really appreciated.
AJ
I've only had my HEX-V2 (3 VIN) and VCDS for 2 days and still not sure if I'm using the software correctly.
My VCDS is registered, validated and updated and as yet I've not been requested to register one of my VIN.
I purchased the cable because a friend advised me that I should have done an adaptations reset and TBA
following a MAF sensor change in February. To be honest the MAF certainly improved the engine performance
but also made the erratic/inconsistent auto gearshifts more noticeable.
I initially tried to do the adaptations on the 02 Auto Trans but that box is greyed out, then tried to do the
adaptations on 01 Engine but only got error messages. I assumed this was due to not having an associated
label file for the engine and have since sent Ross-Tech my control module map files.
My next train of thought was to select basic settings for both engine and auto transmission but once again these
boxes are greyed out.
Any help or advice would be really appreciated.
AJ