Hello Everyone,
I just recently got the new Hex-Net2 due to some issues I have been having with my DSG. I seem to be having trouble in up and down shifts from 1-2,2-3,3-4 and the VW dealership says they don't see anything wrong. I, however, can feel a delay in torque when the car shifts, both in D and in Manual modes. The stall/delay is there as I can feel it every time the car shifts and while it may not be enough for some to feel, when you drive a car for hours everyday that little issue starts to nag at you!
In any case, I'm trying to figure out a way that I can monitor a parameter or module that will allow me to show the 'slip/delay' during shifts. I was hoping someone might be able to give me some pointers/guidance as I'm the last hope for this (dealer has had the car 3 times with no luck)
P.S : Backstory
2K miles : took it in and they said no problems
4K miles: took it in again and told them of crazy peddal vibrations and the same shift problem (they said they checked fluid levels and everything is fine)
7K miles: Took it in again and they just said 'its normal for the DSG' (which it is not, as I've driven other GTIs and they do not exhibit this)
9K Miles: Performed a VCDS reset (via a friend) of all adaptations and followed the Ross-Tech Wiki for the re-adaptation for Clutch packs. This did help dramatically with the brake pedal vibrating, and the shifts *seemed* better for a day or two, but then went right back to its old ways.
Thank you EVERYONE/ANYONE in advance for your help. I'll be combing through everything over the next few days to see what I can find and monitor, but any help is appreciated
I just recently got the new Hex-Net2 due to some issues I have been having with my DSG. I seem to be having trouble in up and down shifts from 1-2,2-3,3-4 and the VW dealership says they don't see anything wrong. I, however, can feel a delay in torque when the car shifts, both in D and in Manual modes. The stall/delay is there as I can feel it every time the car shifts and while it may not be enough for some to feel, when you drive a car for hours everyday that little issue starts to nag at you!
In any case, I'm trying to figure out a way that I can monitor a parameter or module that will allow me to show the 'slip/delay' during shifts. I was hoping someone might be able to give me some pointers/guidance as I'm the last hope for this (dealer has had the car 3 times with no luck)
P.S : Backstory
2K miles : took it in and they said no problems
4K miles: took it in again and told them of crazy peddal vibrations and the same shift problem (they said they checked fluid levels and everything is fine)
7K miles: Took it in again and they just said 'its normal for the DSG' (which it is not, as I've driven other GTIs and they do not exhibit this)
9K Miles: Performed a VCDS reset (via a friend) of all adaptations and followed the Ross-Tech Wiki for the re-adaptation for Clutch packs. This did help dramatically with the brake pedal vibrating, and the shifts *seemed* better for a day or two, but then went right back to its old ways.
Thank you EVERYONE/ANYONE in advance for your help. I'll be combing through everything over the next few days to see what I can find and monitor, but any help is appreciated
Last edited: