- Joined
- Mar 4, 2015
- Messages
- 337
- Reaction score
- 88
- Location
- Rhode Island, USA
- VCDS Serial number
- C?ID=240768
I purchased my wife a Q7 for X-Mas CHEAP! I knew it had and MMI Problem but car runs fantastic... So I thought hey I have gone through a lot with my Audi A8 I'll tackle this lol.. SO with this said I tried to run a complete AutoScan and I cannot at all, It starts then it just cuts out and tells me that failure to communicate (-99)... I have made sure my power management in the computer is good and also check USB Hub to make sure that it was not enabled to power out. Anyways I had some success with the dataBus check and this is what I got below. I could really use some guidance on getting this MMI to work. I unplugged the Fiber lines from several modules in the back boot like the navigation and so on and put a Loop on it, there is not normal red light coming from any of them at all. I have been looking everywhere online with no luck. I would love to post a full AutoScan but I'm not sure what's going on with that or I would have. If I can get some people to shine some light that would be great, thanks so much....
Code:
Thursday,22,December,2016,18:46:15:14758
VCDS -- Windows Based VAG/VAS Emulator Running on Windows 10 x64(Parallels)
VCDS Version 16.8.4.2 (x64)
Data version: 20161129 DS267.0
www.Ross-Tech.com
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Control Module Part Number: 4L0 910 468
Component and/or Version: J533__Gateway H06 0040
Optical Bus Diagnostic : Standard
Controller Electrical Optical
19-CAN Gateway OK OK
07-Control Head(High/D3) OK OK
0E-Media Player 1 OK OK
47-Sound System ERROR ERROR
56-Radio OK OK
37-Navigation OK ERROR
0F-Digital Radio(SAT) OK OK
************************************************************