I believe that I've somehow bricked my micro-CAN cable with the firmware update.
I did the update posted below
I left the cable connected to both my laptop and car (with the ignition on and engine running) for a period of 5 minutes. I didn't see a change in activity since the subsequent screen kept showing 0% complete and a button saying close down below. I eventually clicked "close" so as re-attempt the update process again (big mistake).
Re-attempting the process again only revealed the horror of no further communication between the cable and the car.
I then tried the cable with my other computer with the older 15.7.xx installed just to see if my cable can interface with the car. The same error message was produced. This process even de-activated my copy of the application so I can't even see my serial number.
I've restarted both PCs and even disconnected my car's battery for a few minutes (to see if there is anything in the CAN gateway that is causing an issue) but no success.
Is there a way to force the firmware update again, or do I have to wait until the official software is released (with hopefully a new firmware update)? I'm in Jamaica, so it's not a quick and easy process to ship my cable back to
Ross-Tech, LLC
881 Sumneytown Pike
Lansdale PA 19446, USA