Hey Welder,
Thanks for checking up on me. I have not had much time over the course of the past week to follow along the wiring diagrams just yet so I am still at the point where I was last week which is on the last bolt on the starter before I pull it off for testing.
Last night I was able to get in an hour or so after work before nightfall & the cold and was able to pull a fresh set of codes, clear the finally and then run a fresh Autoscan again. I will be trying to locate J519 for pin testing as well as the starter relay J682 and J623 that NETech mentioned - if those are different form the two relays in the engine bay fuse box. It is a bit overwhelming for me because I am unfamiliar with this car and it seems as though there are more relays being suggested than I can find so I am hoping to find them in the files that I downloaded online. I have been unsuccessful in locating a Haynes or Bentley manual for this car as it appears that they no longer make those for my model year.
Jack had several suggestions regarding terminal 15/30 on fuse panel B/50 circuit - that is what is confusing to me - but I did go an purchase a tone generator in order to troubleshoot his suggestion as I didn't have one over the weekend. By bench checking the I assume he is referring to removing it and connecting power in a setup on a bench but I do not have that luxury as I don't have that sweet of a setup. I'll have to get creative in order to pull that off. I still need to locate J317, J329, J682, J832, J17 and sub fuse panel C along with SC locations (???) as well as A1999 and A192.