Hello Uwe, I submitted my serial number and email that was registered on my account settings... could you please verify me or should I do something else?
Did you read the first post of this thread? I believe you're in Category 2)...Hi, I can only reply to this thread also. Please can I get verified :-)
Feel free to post your question in the New User section of the forum for now. We move your thread to the repair section once get Verified by registering your system with us as explained in the first post of this thread.Hi!
I really need to post a question in the repair section, men it's only for validated users, i have the original vcds, but i did not get valid when i registered to the forum.
Can you help?
It also lights up green for activated on the same page.
Thanks!
You have a PM.I've bought a HEX-USB in September 2007, and never bothered getting verified on here, as I never used it after the yahoo group was finally culled.
I bought it via a UK distributor, but never received a certificate number, and the interface doesn't have a short serial number.
How can I go about getting verified on here?
You can now.Could you please check my account as i cant start a new post
Thanks in Advance
Hi Uwe,
I submitted my serial , could you please verify me ...
Greetings
Done!Hello.
I just bought my HEX-V2 and registered on this forum before I registered my VCDS and I think I'm not a verified user. Could you please check and help ?
Thank you in advance.
Best regards, Tavi
Done.Just filled out the form for the older hex-can interface. Not sure where my certificate is or if I received one(about a 1.5 years ago) included the full serial number. Would like to get verified to make a new post, thank you.
Done.
-Uwe-
Hi - I bought a HEX-V2 unlimited earlier this year and it was registered by RossTech (got the email). Can my forum status be updated please? Thanks