Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: Newbie from Berlin /Germany

  1. #11
    Benevolent Dictator Uwe's Avatar
    Join Date
    Jan 2014
    Location
    Earth
    Posts
    29,002
    Post Thanks / Like
    Blog Entries
    1
    Quote Originally Posted by micha912 View Post
    Can I check the actual height, which is measured via the level sensors, in any MVB?
    There is "Deviation from Nominal Vehicle Height" in MVB 004 and "Absolute Vehicle Height" in MVB 005, but these don't correspond to the directly to measurement between the axle centerline and the to of the fender; the suspension module doesn't have any way to make that measurement; if it did, you and your measuring device tape/stick wouldn't be needed to calibrate the system.

    -Uwe-
    Lock-down of sick people: Quarantine
    Lock-down of healthy people: Tyranny

  2. #12
    Verified VCDS User micha912's Avatar
    Join Date
    Jun 2020
    Location
    Germany
    Posts
    6
    Post Thanks / Like
    Hello everyone, I have looked at the suspension settings again. First I entered and saved the actual measured wheel arch <-> wheel center, since it was then much too high. I have just entered and saved the standard values ​​497/502 again - these heights now only reach in sport mode, so in my opinion then still too high in normal mode. Where do I think wrong? In which measured value blocks can I read the height actually reached / measured? Micha

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •