I have finished the install of a standard mfsw. I followed a kufatec instruction manual but it assumes the van already has a cruise control wire. It did not work. I added a cable from the T10 connector so I am now fully installed and running on pin 17 of the bcm. Others say to use pin 37 but that gives me no function at all.
So the trip display, phone, stereo controls work perfectly.
However I cannot get the cruise to work at all.
It does not even know the buttons are there.
I have done most of the coding where I had options to do so. When I can to activating Cruise in the engine 01 module. I cannot seem to change it, I cannot even change any settings to be honest. I get a coding rejection. Error 00: unknown (0x00). I also got a coding rejection. Error 31: unknown (0x00) but that may have been when my engine was running.
Can anyone please shed some light on what would be stopping me from accessing to code the module?
I am fully up to date. version 20.4.0
So the trip display, phone, stereo controls work perfectly.
However I cannot get the cruise to work at all.
It does not even know the buttons are there.
I have done most of the coding where I had options to do so. When I can to activating Cruise in the engine 01 module. I cannot seem to change it, I cannot even change any settings to be honest. I get a coding rejection. Error 00: unknown (0x00). I also got a coding rejection. Error 31: unknown (0x00) but that may have been when my engine was running.
Can anyone please shed some light on what would be stopping me from accessing to code the module?
I am fully up to date. version 20.4.0