I use a HEX + CAN interface for VW T6 of 2017.
after a auto-scan with VCDS 19.6.2, I find error codes with dates of 2026 and 2033.

Why are the dates not correct?
The problem is it a bad time management in the calculator or a version too old my ross-tech interface.

Thank you for answer

------------------------
Extract off auto-sacn

Sunday,19,January,2020,09:43:07:35032
VCDS -- Windows Based VAG/VAS Emulator Running on Windows 10 x86
VCDS Version: 19.6.2.0
Data version: 20190930 DS308.0
www.Ross-Tech.com

VIN: WV2ZZZ7HZHH050025 License Plate:

Chassis Type: 7H-VN75 (7E0)
Scan: 01 03 04 08 09 10 15 17 18 19 25 5F 61 69

VIN: WV2ZZZ7HZHH050025 Mileage: 17880km-11110miles

01-Engine -- Status: Malfunction 0010

-------------------------------------------------------------------------------
Address 01: Engine (2D2D2-CXFA) Labels:. 04L-907-309-V2.clb
Part No SW: 04L 906 056 KM HW: 04L 907 445
Component: R4 2.0l TDI H02 6186
Revision: 23002001
Coding: 0019401C432401080000
Shop #: WSC 02737 790 50316
ASAM Dataset: EV_ECM20TDI03004L906056KM 004013
ROD: EV_ECM20TDI03004L906056JT.rod
VCID: 020B31B49587C95FB1-8056

2 Faults Found:
30540 - Throttle Position Sensor (G69)
P0121 00 [032] - Implausible Signal
Intermittent - Not Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Status: 00000001
Fault Priority: 2
Fault Frequency: 1
Mileage: 15875 km
Date: 2033.01.03
Time: 11:23:05



27176 - Coolant Pump for Intercooler
P190D 00 [032] - Mechanical Malfunction
Intermittent - Not Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Status: 00000001
Fault Priority: 2
Fault Frequency: 7
Mileage: 12789 km
Date: 2026.01.14
Time: 07:03:32