Coding 11

Hi everyone. I have a 2016 vw passat 1.8 R line. I want access my coding 11 function on vcds but it is greyed out and unable to click on it. Anyone know how to fix this or do I have to call ross tech support. Any help would be appreciated.

We'll need to know which module you are trying to use Coding 11 on, and also for you to post a VCDS Auto-Scan of your 2016 Passat for context.

Hi i have the sane problem
trying to do forced regeneration on 3.0L engine.

Particle Filter Emergency Regeneration

Prerequisites:

Ignition ON
Engine ON (Idle)
Oil Temperature above 70 °C (see MVB 007.2)
Particle Filter Load below 68g (see MVB 104.3)
If the Particle Filter Load is above 68g the Particle Filter needs to be replaced since the car may burn down when regenerating.
Engine Hood CLOSED
Parking Brake ENGAGED
Transmission in (P)ARK
Temperatures at the Exhaust System may rise up to 300 °C!!!
No Fault Codes Stored
Power Consumers ON (Light, Seat Heating, Front/Rear Window Heater, Climate Control)

The Regeneration may take up to 40 minutes, the engine speed automatically increases to about 1500 RPM.

[Select]
[01 - Engine]

[Coding-II - 11]

Start Regeneration by Entering 10016.

[Do It!]

[Meas. Blocks - 08]
Select all 3 Groups at once 100, 101 and 102
[Go!]
MVB 100.1: Engine Speed
MVB 100.3: Regeneration Counter/Timer
MVB 100.4: Regeneration Abort recognized (0 = No Abort/1 = Abort recognized)
MVB 101.4: Regeneration Status (001 = Heating Up, 010 = Regeneration, 100 = Cooling Down)
MVB 102.1: Temperature before Catalyst
MVB 102.2: Temperature before Particle Filter
[Done, Go Back]
[Close Controller, Go Back - 06]

but code-II is greyed and i cannot start regeneration.

thanks.

Jeromeo said:

Hi i have the sane problem
trying to do forced regeneration on 3.0L engine.

Click to expand...

Have you posted a VCDS Auto-Scan of your car? - It will help the experts to answer your question.