Hi i have the sane problem
trying to do forced regeneration on 3.0L engine.
Particle Filter Emergency Regeneration
Prerequisites:
Ignition ON
Engine ON (Idle)
Oil Temperature above 70 °C (see 007.2)
Particle Filter Load below 68g (see 104.3)
If the Particle Filter Load is above 68g the Particle Filter needs to be replaced since the car may burn down when regenerating.
Engine Hood CLOSED
Parking Brake ENGAGED
Transmission in (P)ARK
Temperatures at the Exhaust System may rise up to 300 °C!!!
No Fault Codes Stored
Power Consumers ON (Light, Seat Heating, Front/Rear Window Heater, Climate Control)
The Regeneration may take up to 40 minutes, the engine speed automatically increases to about 1500 RPM.
[Select]
[01 - Engine]
[Coding-II - 11]
Start Regeneration by Entering 10016.
[Do It!]
[Meas. Blocks - 08]
Select all 3 Groups at once 100, 101 and 102
[Go!]
100.1: Engine Speed
100.3: Regeneration Counter/Timer
100.4: Regeneration Abort recognized (0 = No Abort/1 = Abort recognized)
101.4: Regeneration Status (001 = Heating Up, 010 = Regeneration, 100 = Cooling Down)
102.1: Temperature before Catalyst
102.2: Temperature before Particle Filter
[Done, Go Back]
[Close Controller, Go Back - 06]
but code-II is greyed and i cannot start regeneration.
thanks.