If I'm understanding correctly, the engine readiness status is a check on emissions/pre-emissions? It spits out a binary code for the following fields:
1. Exhaust gas recirculation
2. O2 sensor heating
3. O2 sensors
4. A/C
5. SAI
6. EVAP
7. Catalyst heating
8. Catalytic converter
Should I interpret the following status in the scan below as the O2 sensor and Catalytic converter not being ready or that there is a failure with that component?
Address 01: Engine (CCA) Labels:. 06E-907-551-CAJ.clb
Part No SW: 4F1 910 551 D HW: 4F1 907 551
Component: 3.0l V6 TFSI 0050
Revision: --H07--- Serial number:
Coding: 010D000A190F0120
Shop #: WSC 02325 785 00200
VCID: 244C43D5E7DF7E6FE3-8070
No fault code found.
Readiness: 0010 0001
1. Exhaust gas recirculation
2. O2 sensor heating
3. O2 sensors
4. A/C
5. SAI
6. EVAP
7. Catalyst heating
8. Catalytic converter
Should I interpret the following status in the scan below as the O2 sensor and Catalytic converter not being ready or that there is a failure with that component?
Address 01: Engine (CCA) Labels:. 06E-907-551-CAJ.clb
Part No SW: 4F1 910 551 D HW: 4F1 907 551
Component: 3.0l V6 TFSI 0050
Revision: --H07--- Serial number:
Coding: 010D000A190F0120
Shop #: WSC 02325 785 00200
VCID: 244C43D5E7DF7E6FE3-8070
No fault code found.
Readiness: 0010 0001