Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: VW Polo 2011 with s/hand engine ecu faults in ecu

  1. #11
    NostraJackAss Jack@European_Parts's Avatar
    Join Date
    Jan 2014
    Location
    1001 State Route 17K Montgomery New York 12549
    Posts
    18,655
    Post Thanks / Like
    Is G17 standard equipment or is bay empty in ecu plug when compare to WD takes place?
    European Parts Emporium/Performance / Immobilizer Solutions EPE
    Certified Master Trained NY/BAR/BAD 7076062/ASE/SAE/NASTF Legal Factory Authorized/Licensed GeKo/FaZit # 403738
    Specializing in Custom Services IE: "welding-fabrication" / EPA-SMOG Update or Pass-Thru-Programming / Data Transfer / Immobilizers & OEM Quality Parts
    Above Magic! No Written record, AUTO-SCAN or Appointment = NO HELP!
    www.FixMyEuro.com <<<<<CLICK HERE! or vwemporium@aol.com ( JPPSG & Unverified members need not PM me & Please don't email or call facility for free tech support...use the forum )
    Getting you CONTROL again of your property - TAKE IT! In Conjunction with.........

  2. Likes Dana liked this post
  3. #12
    Ross-Tech Employee Dana's Avatar
    Join Date
    Jan 2014
    Location
    United States
    Posts
    3,899
    Post Thanks / Like
    Hi guys,

    Lots of good suggestions here. The support crew at HEX Microsystems contacted us via e-mail on behalf of the OP and I replied however I'll paste the bulk of that reply below in the event the final feedback ends up here.

    Code:
    I agree with the G17 suggestions in forum.  G17 is standard equipment in
    most parts of the world and address 17-Instruments relays the
    information over the databus so modules such as 01-Engine, 03-ABS and
    similar have the outside air temp information.
    
    I didn't dig into wiring diagrams, and that's not a bad idea per Jack's
    suggestion to make sure the wiring is present and connected to the
    proper component, however PartsLink24 shows a factory fitted ambient
    temperature sensor.  Temp screen shot link:
    
    https://media.trillian.im/media/?m=aW1hZ2UvcG5nLDEyOTEsNzkzLIENjhJQUaHkOnNzlgNiqSZwHSST2g9TUV4NJeui%2BPQR
    
    I'd make sure 1J0 919 379 A is both installed and that the wiring
    diagram matches the terminal arrangements/wire colors at the sensor itself.
    
    If that doesn't shed any light I suppose it might not hurt to verify the
    instrument cluster or the wiring at it wasn't modified.  Also, measuring
    block group 002 in address 17 contains useful info:
    
    002,0,General
    002,1,Odometer
    002,2,Fuel Level
    002,3,Fuel Sender,Resistance
    002,4,Ambient,Temperature
    
    You might want to compare that data to MVB 008.1 (per NEtech) in address 08.
    
    Best,
    Dana

  4. Likes Uwe liked this post

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •