A while ago I swapped my original wheels with TPMS and disabled it on the car : >17 instruments, > adaption > Channel 61 -512 from value.
I’d like to reactivate the system and re use the sensors in my new wheels.
Unfortunately in my haste, I’ve had the sensors removed from my old wheels before testing them so could be wasting my time fitting the into the new wheels.
My question is, do they need to be pressurised for the car to see them as I’ve reactivated the system but getting TPMS in yellow on the DIS?
I’ve tried pressurising them by placing them in a (dry) garden weed sprayer near the rear of the cars antenna and depressurising to wake them up.
In M/B’s all the serial numbers are present in wheel set 2, are these saved from before the system was deactivated or would these have been picked up on reactivation?
All show no actual pressure whether pressurised or not.
Only thing I’ve not tried is taking it for a drive, think I’ll try with the sensors loose in the car then pressurised.
Thanks
I’d like to reactivate the system and re use the sensors in my new wheels.
Unfortunately in my haste, I’ve had the sensors removed from my old wheels before testing them so could be wasting my time fitting the into the new wheels.
My question is, do they need to be pressurised for the car to see them as I’ve reactivated the system but getting TPMS in yellow on the DIS?
I’ve tried pressurising them by placing them in a (dry) garden weed sprayer near the rear of the cars antenna and depressurising to wake them up.
In M/B’s all the serial numbers are present in wheel set 2, are these saved from before the system was deactivated or would these have been picked up on reactivation?
All show no actual pressure whether pressurised or not.
Only thing I’ve not tried is taking it for a drive, think I’ll try with the sensors loose in the car then pressurised.
Thanks