Results 1 to 2 of 2

Thread: Comeback P0333

  1. #1
    New User
    Join Date
    Dec 2018
    Location
    USA
    Posts
    1
    Post Thanks / Like

    Question Comeback P0333

    1.8t AWM passat has a new knock sensor. the code came from messing around the chain tensioner.

    did not have the engine at TDC before taking off the intake camshaft. slapped it back together with correct marks/16 links. still made sure to rotate it by hand without plugs.
    ran like shit for 10 startups until i did the chain again. had to move the intake valves into correct position by moving the camshaft without the chain on it.

    car runs fine/good compression but long trips will bring P0333 back everytime. the only code.

    please advise
    Last edited by no0bi1; 11-19-2019 at 04:13 PM.

  2. #2
    Ross-Tech Employee DrPeter's Avatar
    Join Date
    Jan 2014
    Location
    16.4905 S, 151.7375 W
    Posts
    1,180
    Post Thanks / Like
    Hello,

    We do have a Ross-Tech wiki page for this fault code, see the link below.

    P0333 - Knock Sensor 2 (G66): Signal too High


    I would like to add, you can have a look at the Measuring Value Block group [026] to 'see' the Knock Sensor Voltages for Cylinder 1-4.

    Please post a complete vehicle Auto-Scan when posting questions on the Ross-Tech forum,

    Thank you,

    drpeter

  3. Likes Uwe liked this post

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •