pretty sure it's a settings issue on my end. running windows 10 fwiw.
went to replace a G200 and had to do the log in. enter the log in code and never got the "log in accepted" pop up.
being a new user and not wanting to do anything bad, I had a friend link in with teamviewer to walk me thru the procedure. he said the pop up was working on his end, and that I ran the adaptation just fine.
what do I need to check to correct this? [redacted] is the license # I have. also, I get a communication error when trying to access NAV and Radio but my other scanner will get right in. I can watch the screen on the radio go into DIAG with VCDS, and it will get as far as a radio p/n before it aborts.
pretty sure it's a setting on my end causing this. I can post an autoscan if needed
went to replace a G200 and had to do the log in. enter the log in code and never got the "log in accepted" pop up.
being a new user and not wanting to do anything bad, I had a friend link in with teamviewer to walk me thru the procedure. he said the pop up was working on his end, and that I ran the adaptation just fine.
what do I need to check to correct this? [redacted] is the license # I have. also, I get a communication error when trying to access NAV and Radio but my other scanner will get right in. I can watch the screen on the radio go into DIAG with VCDS, and it will get as far as a radio p/n before it aborts.
pretty sure it's a setting on my end causing this. I can post an autoscan if needed
Last edited by a moderator: