Results 1 to 3 of 3

Thread: Haldex gen 5 pinout (Golf mk7, A3 8V)

  1. #1
    Verified VCDS User
    Join Date
    Aug 2017
    Location
    Slovenia
    Posts
    9
    Post Thanks / Like

    Haldex gen 5 pinout (Golf mk7, A3 8V)

    Hi,
    I am looking for a pinout for Haldex controller for my Audi A3 8VA 2013 year 2.0tdi quattro. I have no communication with haldex controller, so there are DTCs in most systems + esp light and parking sensors not working (no Awd also).
    There are 2 connectors, 1 for pump, the other one is for controller. 1 positive wire, 1 earth, 2x can, ans one more that I donít know what it is for.
    Anyone knows or has a pinout?
    I would like to work on it on the bench..
    Best regards,
    Matic

  2. #2
    Ross-Tech Employee
    Join Date
    Jan 2014
    Location
    Near Philadelphia, PA, USA
    Posts
    1,030
    Post Thanks / Like
    Blog Entries
    3
    I think you will find the information you seek by buying access to the erwin.VW website and downloading the wiring diagrams needed.

    The web site links are found in the Ross-Tech Wiki: Official Factory Repair Information

  3. Likes Uwe liked this post
  4. #3
    Verified VCDS User NZDubNurd's Avatar
    Join Date
    Nov 2014
    Location
    New Zealand
    Posts
    1,017
    Post Thanks / Like
    You need to check a diagram, but the other wire is probably a brake signal - a backup for the haldex, if it doesn't receive the brake signal over CAN.

    If you have no comms, you could have a power or wiring issue... but the module may be dead too - sometimes they get water in them.
    Allan
    The R32ran Thread
    How to post a full Auto-Scan
    "Duct tape can't fix stupid, but it can muffle the sound"

  5. Likes Uwe liked this post

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •