Dpf pressure sensor problem after stage 2

   #1  

MrGurkan

New Member
Joined
Jul 16, 2019
Messages
1
Reaction score
0
Location
Sweden
I have a problem I can't get rid of and have a long road trip in front of me. After I had done stage 2 and removed catalyst and diesel particulate filter at a workshop that programmed them away from ecu, I got problem with dpf pressure sensor. I have tested change sensor, checked leakage and wiring to sensor but still does not work. I have read that it should help to do a calibration of sensor with vcds. I have search but I cannot get into Coding II with code 30605. Best regards Robert from sweden

Code:
Tuesday,16,July,2019,11:47:29:02028
VCDS -- Windows Based VAG/VAS Emulator Running on Windows 10 x64
VCDS Version: 19.6.1.0 (x64)
Data version: 20190529 DS308.0
www.Ross-Tech.com


VIN: WAUZZZ4F6BN062375 License Plate: 


Chassis Type: 4F-AU56 (4F0)
Scan: 01 02 03 05 08 09 0E 15 16 17 18 19 34 42 46 4F 52 53 55 56
5F 62 69 6D 72 76

VIN: WAUZZZ4F6BN062375 Mileage: 179500km-111536miles

01-Engine -- Status: Malfunction 0010
02-Auto Trans -- Status: Malfunction 0010
03-ABS Brakes -- Status: Malfunction 0010
04-Steering Angle -- Status: OK 0000
05-Acc/Start Auth. -- Status: OK 0000
08-Auto HVAC -- Status: Malfunction 0010
09-Cent. Elect. -- Status: Malfunction 0010
0E-Media Player 1 -- Status: OK 0000
15-Airbags -- Status: OK 0000
16-Steering wheel -- Status: OK 0000
17-Instruments -- Status: OK 0000
18-Aux. Heat -- Status: OK 0000
19-CAN Gateway -- Status: Malfunction 0010
34-Level Control -- Status: Malfunction 0010
42-Door Elect, Driver -- Status: OK 0000
46-Central Conv. -- Status: OK 0000
4F-Centr. Electr. II -- Status: OK 0000
52-Door Elect, Pass. -- Status: OK 0000
53-Parking Brake -- Status: OK 0000
55-Headlight Range -- Status: OK 0000
56-Radio -- Status: OK 0000
5F-Information Electr. -- Status: OK 0000
62-Door, Rear Left -- Status: OK 0000
69-Trailer -- Status: OK 0000
6D-Trunk Elect. -- Status: OK 0000
72-Door, Rear Right -- Status: OK 0000
76-Park Assist -- Status: OK 0000

-------------------------------------------------------------------------------
Address 01: Engine (CDY) Labels: Redir Fail!
Part No SW: 4F9 910 402 A HW: 4F0 907 401 E
Component: 3.0TDI EDC17G004AG 0080 
Revision: 16H14--- Serial number: 
Coding: 0125002C191F0928
Shop #: WSC 40970 222 95490
VCID: 247E7C85E7DC136FDD-8070

4 Faults Found:
001139 - Exhaust Pressure Sensor 1 
P0473 - 001 - Signal too High - MIL ON
Freeze Frame:
Fault Status: 11100001
Fault Priority: 2
Fault Frequency: 1
Reset counter: 255
Mileage: 178502 km
Time Indication: 0
Date: 2019.07.15
Time: 13:47:56

Freeze Frame:
RPM: 1680 /min
Speed: 30.2 km/h
Pressure: 94 mbar
Temperature: 28.8°C
Temperature: -5.9°C
Pressure: 6 mbar
(no units): 211.5

001152 - Coolant Fan Control Circuit 1 
P0480 - 000 - Electrical Malfunction
Freeze Frame:
Fault Status: 01100000
Fault Priority: 2
Fault Frequency: 1
Reset counter: 255
Mileage: 178502 km
Time Indication: 0
Date: 2019.07.15
Time: 13:47:56

Freeze Frame:
RPM: 1680 /min
Speed: 30.2 km/h
Temperature: 28.8°C
Mass Air / Rev.: 487.6 mg/str
Duty Cycle: 19.7 %
Temperature: -5.9°C

001683 - Fan 2 Control Circuit 
P0693 - 000 - Short to GND
Freeze Frame:
Fault Status: 01100000
Fault Priority: 2
Fault Frequency: 1
Reset counter: 255
Mileage: 178502 km
Time Indication: 0
Date: 2019.07.15
Time: 13:48:06

Freeze Frame:
RPM: 1281 /min
Speed: 23.5 km/h
Temperature: 27.9°C
Mass Air / Rev.: 376.0 mg/str
Duty Cycle: 19.7 %
Temperature: -5.9°C

001153 - Coolant Fan Control Circuit 2 
P0481 - 000 - Electrical Malfunction
Freeze Frame:
Fault Status: 01100000
Fault Priority: 2
Fault Frequency: 1
Reset counter: 255
Mileage: 178502 km
Time Indication: 0
Date: 2019.07.15
Time: 13:48:06

Freeze Frame:
RPM: 1260 /min
Speed: 24.6 km/h
Temperature: 27.9°C
Mass Air / Rev.: 340.8 mg/str
Duty Cycle: 19.7 %
Temperature: -5.9°C

Readiness: 1 1 0 0 0 

-------------------------------------------------------------------------------
Address 02: Auto Trans Labels: 09L-927-760.lbl
Part No SW: 4F2 910 156 R HW: 09L 927 156 C
Component: AG6 09L 3,0 TDI RdW 0050
Revision: --H05--- Serial number: 4608058
Coding: 0000001
Shop #: WSC 02325 785 00200
VCID: 345E8CC5573C83EF4D-8060

1 Fault Found:
006241 - Throttle Position Sensor (G79) 
P1861 - 000 - Error Message from ECU - Intermittent
Freeze Frame:
Fault Status: 00100000
Fault Priority: 0
Fault Frequency: 1
Reset counter: 255
Mileage: 178418 km
Time Indication: 0
Date: 2019.07.14
Time: 11:40:17


-------------------------------------------------------------------------------
Address 03: ABS Brakes Labels: 4F0-910-517.clb
Part No SW: 4F0 910 517 AM HW: 4F0 614 517 BK
Component: ESP8 quattro H03 0100 
Revision: 00000000 Serial number: 00000000000000
Coding: 0000396
Shop #: WSC 02325 785 00200
VCID: 6FD443A97E9AE03770-803A

1 Fault Found:
01314 - Engine Control Module 
013 - Check DTC Memory - Intermittent
Freeze Frame:
Fault Status: 00101101
Fault Priority: 3
Fault Frequency: 1
Reset counter: 4
Mileage: 178418 km
Time Indication: 0
Date: 2019.07.14
Time: 11:40:16

Freeze Frame:
Hex Value: 0x0000
Hex Value: 0x0082
Hex Value: 0x0029
Hex Value: 0x0192
Hex Value: 0x00FF
 
   #2  

Viking

Verified VCDS User
Verified
Joined
Nov 2, 2015
Messages
485
Reaction score
496
Location
UK
VCDS Serial number
C?ID=151455
If you've had the dpf removed then I'm curious as to why the ECU is reading the pressure sensor. I'd probably be back to the tuner (or workshop) who supposedly removed them from the ECU.
 
Back
Top