Page 3 of 3 FirstFirst 123
Results 21 to 23 of 23

Thread: HEX-NET will to read engine addresses

  1. #21
    Ross-Tech Employee
    Join Date
    Jan 2014
    Location
    USA
    Posts
    859
    Post Thanks / Like
    Since you have been able to get it to work at some point in the past, the first thing I would suggest is to make sure you are pushing the interface all the way into the socket. There have been cases where the interface isn't seated all the way and it has intermittent contact with some pins. If the interface receives anything over can, you should see CAN: OK in [Options] -> [Self Test]. Since the powertrain bus is directly on the DLC here, there should definitely be traffic if the wiring/contact is good.

  2. Likes Uwe liked this post
  3. #22
    Verified VCDS User
    Join Date
    Apr 2014
    Location
    Hudson Valley
    Posts
    50
    Post Thanks / Like
    Thank you, Shaun. I will try that, and also inspect the connector in the A4 based on Uwe's image showing the pin locations.

  4. #23
    Verified VCDS User
    Join Date
    Apr 2014
    Location
    Hudson Valley
    Posts
    50
    Post Thanks / Like
    Uwe, thanks for sending the diagram.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •