- Joined
- Mar 9, 2015
- Messages
- 475
- Reaction score
- 336
- Location
- Australia
- VCDS Serial number
- C?ID=241363
Got the DQ500 out again today.
Inspected the clutches - looked brand new.
Inspected the mechatronics visually and couldn't see anything obvious.
No blockages in oil galleries, no debris in the filter.
Replaced the K1 and K2 clutch solenoids and put the gearbox back in, without the transfer case or driveshafts.
Basic settings now fails earlier with main reason 0, sub reason 7.
There is no drive at all when engaging D or R , can only see the flywheel moving.
No fault codes from trans.
I'm going to have to put the DQ250 back in at this stage because I need to get the car back on the road.
Unless anyone can offer any suggestions? I'm open to trying anything....
Inspected the clutches - looked brand new.
Inspected the mechatronics visually and couldn't see anything obvious.
No blockages in oil galleries, no debris in the filter.
Replaced the K1 and K2 clutch solenoids and put the gearbox back in, without the transfer case or driveshafts.
Basic settings now fails earlier with main reason 0, sub reason 7.
There is no drive at all when engaging D or R , can only see the flywheel moving.
No fault codes from trans.
I'm going to have to put the DQ250 back in at this stage because I need to get the car back on the road.
Unless anyone can offer any suggestions? I'm open to trying anything....