Problems with rough idle, lambda control bank1 vs bank2 is way off

   #1  

Znippie

Verified VCDS User
Verified
Joined
May 6, 2018
Messages
39
Reaction score
17
Location
Norway
VCDS Serial number
C?ID=328489
Hey!
I got an issue with my 2.7 biturbo BES engine.
At idle my lambda values are waaay off. Even when im driving with some boost i can see that the lambda control bank1 and 2 is far away from eachother. I have not been able to log this yet.
As you can see from my screenshot below, under group 031, the specified voltage for bank1 is somehow similar to the actual voltage on bank2. And visa verca for the other bank.
Is it possible to connect the lambda to the wrong connector in the wiring harness? :confused:

CLzP0E7.png


My coils and spark plugs are brand new, installed them last week to hopefully eliminate the problem
No faultcodes on the ECU, and no misfires.
Any suggestions?
 
Last edited:
   #2  

jyoung8607

FoRT
Verified
Joined
Feb 25, 2014
Messages
2,780
Reaction score
4,490
Location
Cincinnati, OH
VCDS Serial number
C?ID=25607
As you can see from my screenshot below, under group 031, the specified voltage for bank1 is somehow similar to the actual voltage on bank2. And visa verca for the other bank.
Is it possible to connect the lambda to the wrong connector in the wiring harness? :confused:
Heh, it's been done before, seen here more than once. Switching them is an easy test, why not try it?
 
  • Like
Reactions: Uwe
   #4  

Jack@European_Parts

Gone But Not Forgotten
Professional VCDS User
Joined
Jan 29, 2014
Messages
21,923
Reaction score
9,308
Location
Montgomery, NY, USA
VCDS Serial number
C?ID=57337
Trace the circuit's using WD and verifying sensor locations.
 
Back
Top