I have a 10 VIN Hex-V2 interface and have registered two VINs against it.
This shows fine when you go to the interface config sheet (see photo below, reads “VINs stored: 2”.
However on the much easier to access About screen it shows “VIN(s) used: 1/10”.
So it appears the about screen has a bug showing n-1 for the VIN count? Is this just my software (latest?) or is it a thing?
Also, as a suggestion for these VIN limited interfaces it would be great if on a screen somewhere you could click it and see a table of the registered VINs for that interface; ideally with a box or two to store notes/information against each entry such as “License Plate” and “Comments”.
It would allow us to keep track of what VINs we have registered and who’s vehicles etc they are for our own notes?
Thanks!
This shows fine when you go to the interface config sheet (see photo below, reads “VINs stored: 2”.
However on the much easier to access About screen it shows “VIN(s) used: 1/10”.
So it appears the about screen has a bug showing n-1 for the VIN count? Is this just my software (latest?) or is it a thing?
Also, as a suggestion for these VIN limited interfaces it would be great if on a screen somewhere you could click it and see a table of the registered VINs for that interface; ideally with a box or two to store notes/information against each entry such as “License Plate” and “Comments”.
It would allow us to keep track of what VINs we have registered and who’s vehicles etc they are for our own notes?
Thanks!