Results 1 to 2 of 2

Thread: Changing data parameter units

  1. #1
    Verified VCDS User
    Join Date
    Mar 2019
    Location
    Canada
    Posts
    1
    Post Thanks / Like

    Changing data parameter units

    Greetings,

    Yesterday I had in a 2013 Audi A4 2.0L that was tripping for fuel rail too high. When looking at the data parameters, the high pressure desired read in MPa, while the actual read in kPa. Is there a way to change the unit settings so they both read the same so when graphing the data both are visable instead of going off the chart? Or maybe there is a way to change the graph settings to accept the high number as displayed in kPa.

    Thanks.

  2. #2
    Benevolent Dictator Uwe's Avatar
    Join Date
    Jan 2014
    Location
    Earth
    Posts
    22,510
    Post Thanks / Like
    Blog Entries
    1
    Graph settings can certainly be adjusted.
    http://www.ross-tech.com/vag-scope/index.html

    You click on the value you wish to adjust the vertical scale for, the sent a Max and Min, then click back on the value.

    Units from the car cannot be adjusted. We don't decide those; some guys in white lab coats and titles like "Dr.Dipl.Ing." in ze Vaterland do that.

    -Uwe-
    The engineering problems are likely insurmountable. It would be like proposing to land a rocket booster section on a barge floating in the middle of the ocean.

  3. Likes PetrolDave liked this post

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •