Results 1 to 6 of 6

Thread: Limp mode valve errors Audi A8 D3 3.0tdi

  1. #1
    Pirate
    Join Date
    Mar 2019
    Location
    South Africa
    Posts
    3
    Post Thanks / Like

    Limp mode valve errors Audi A8 D3 3.0tdi

    Hi, I recently bought an A8, been standing for two years without a turbo. Bought a tested 2nd hand one and car has many errors. Had a similar problem on the park brakes with many grounds and low volt errors but after fixing the switch, all errors were gone. I can almost not believe that all these components are faulty. All valves are loose. Only error o the screen is the glow plug light. Not sure if that can cause limp mode.

    Mode 07: Pending emission related fault codes

    Address 7E8: 8 Faults Found:
    P2426 - Exhaust Gas Recirculation Cooling Valve Control Circuit: Short to Ground
    P2011 - Intake Manifold Flap; Bank 2: Electrical Malfunction
    P2008 - Intake Manifold Flap; Bank 1: Electrical Malfunction
    P2100 - Throttle Actuator Control Circuit: Open Circuit
    P0489 - EGR Valve Position Control Circuit: Short to GND
    P0243 - Solenoid Valve for Boost Pressure Control (N75): Malfunction
    P2011 - Intake Manifold Flap; Bank 2: Electrical Malfunction
    P2008 - Intake Manifold Flap; Bank 1: Electrical Malfunction

    I'm suspecting something small affecting all these areas, coding perhaps...?

    Would appreciate some advice

    Tertius

  2. #2
    Verified VCDS User PetrolDave's Avatar
    Join Date
    Dec 2014
    Location
    South Molton, UK
    Posts
    2,531
    Post Thanks / Like
    To be able to answer that we'll need you to post a FULL UNEDITED VCDS Auto-Scan.

  3. Likes Eric, Uwe liked this post
  4. #3
    Pirate
    Join Date
    Mar 2019
    Location
    South Africa
    Posts
    3
    Post Thanks / Like
    Code:
    Removed.  Data from a clone/pirate copy of VCDS is not welcome here.
    Last edited by Uwe; 03-05-2019 at 11:01 AM.

  5. #4
    VCDS Distributor Boki Ar's Avatar
    Join Date
    Oct 2014
    Location
    Arandjelovac, Serbia
    Posts
    1,139
    Post Thanks / Like
    Thread lock until further notice.

  6. Likes Uwe liked this post
  7. #5
    Benevolent Dictator Uwe's Avatar
    Join Date
    Jan 2014
    Location
    Earth
    Posts
    25,295
    Post Thanks / Like
    Blog Entries
    1
    Getting help in this forum requires the use of a legitimate VCDS system.

    They are available directly from us:
    https://store.ross-tech.com/shop/cat/VCDS

    ... Or from any of our authorized resellers:
    http://www.ross-tech.com/distributors.php#za

    Let us know if/when you gets one and we'll adjust your forum status.

    -Uwe-
    The engineering problems are likely insurmountable. It would be like proposing to land a rocket booster section on a barge floating in the middle of the ocean.

  8. #6
    Pirate
    Join Date
    Mar 2019
    Location
    South Africa
    Posts
    3
    Post Thanks / Like
    Sorry, didn't know that it is a clone... guess I've been conned

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •