You wrote, that you did the same coding as for the Passat B8; what where those steps? What was the outcome?
I did the process below.
1. Go to module 17, instrument panel
2. Enter extended coding
3. Access the byte mode
4. In byte 4, activate bit 6
5. In byte 11, activate bit 1
6. Confirm with the Seen, code 25327
7. We went to the Modules menu.
8. -
9. Go to module A5, front sensors, driver assistance system
10. Enter extended coding
11. Access the byte mode
12. In byte 16, activate bit 7
13. Confirm with the Seen.
14. Return to the Module A5 menu
15. Enter the Security Code
16. Enter the code 20103
17. Enter Adaptations
18. In Customization, change from "On" to "Off"
19. We return to adaptations.
20. In Intensity of warning. Lane change assistant :, change from "Medium" to "Selection via Menu"
21. In Personaliz. interv. moment with terminal 15 on:, check that "Last setting" is checked
22. We went to the Modules menu.
2. 3. -
24. Go to module 5F Information electronics.
25. Enter Adaptations
26. Go to Car_Function_List_BAP_Gen2:
27. In LDW_HCA_0x19:, change from "Off" to "On"
28. Confirm with the Seen.
29. Back to Adaptations
30. Go to Car_Function_Adaptations_Gen2:
31. In menu_display_Lane_Departure_Warning:, change from "Off" to "On"
32. Confirm with the Visto
33. In menu_display_Lane_Departure_Warning_over_threshold_high:, change from "Off" to "On"
34. Confirm with the Visto
35. We go to the Modules menu.
36. -
37. Go to module 44 Power steering.
38. Enter extended coding
39. Access the byte mode
40. In byte 3, activate bit 0
41. Confirm with the Seen, code 19249
42. We left
43. ---
44. We restart the Infotainment by pressing the ignition wheel for 20 seconds
45. We activate in the menu Car / assistants to the Driving the Lane Assist
Making all that above, Lane Assist didn't work.
Do you know what else can I do to make Lane Assist work? Because in my country, Lane Assist didn't come able in factory.
I need to coding the Lane Assist by .
Thanks a lot for your support.