-
Verified VCDS User

Originally Posted by
Uwe
[Sigh]
This sums up my daily life at work.
Volt: My boss.
Ohm: Our Rules, Standards and Bureaucracy.
Amp: Me. Struggling. Scratching through the dirt, doing all of the work. Measured by my friend; Watt.
-
Post Thanks / Like - 3 Likes
-
Verified VCDS User
hey at least you have a job :P
-
Hello Iichel
I see regardinf the BCM that i have, all of the lights from the LED cluster Works but i just want to confirm if there was any option to clear this BULB warning
-

Originally Posted by
PetrolDave
Sounds like your best option is to add resistors in parallel with the indicator LEDs - this is what I had to do on my other car (a Citroen C1) to make them flash at the correct rate.
Hello Petrol
I add the Led resistor and a pair of Diodes to switch from the stop light and the stop indicators ; D
Thanks
-
Hi Borja
The only way to clear the warning light is to fix resistors to the indicator lights as it appears that this BCM does not have another way. You would probably need to get 50w resistors - one for each side. Be careful where you mount them as they get very hot.
-
Post Thanks / Like - 2 Likes