- Joined
- Dec 16, 2014
- Messages
- 7,986
- Reaction score
- 7,820
- Location
- Westbury, UK
- VCDS Serial number
- C?ID=1423
After downloading and installing VCDS Beta 18.7.1 I ran Config which said my HEX-NET needed an update from CB 0.4427 to CB 0.4430 so I clicked on update and left it running.
After an hour (I was busy doing some DIY) I came back to find that VCI Config was shown as Not Responding and the progress bars were stuck, so I had no choice but to quit VCI Config.
Now when I power up my HEX-NET the separte LED comes on green for a few seconds then flashes red, and the other two LEDs by the red button never turn on.
How can I get my HEX-NET working again?
After an hour (I was busy doing some DIY) I came back to find that VCI Config was shown as Not Responding and the progress bars were stuck, so I had no choice but to quit VCI Config.
Now when I power up my HEX-NET the separte LED comes on green for a few seconds then flashes red, and the other two LEDs by the red button never turn on.
How can I get my HEX-NET working again?