uWE and peter helped with assessing DPF condition on 06 V10, only 1 problem left HVAC.. Intermitanta/c RCV operation c dtc code 00898 on auto scan some times , last eve went to HVAC control MVB 13 field 1 gave 8 in field 1 which indicates compressor off;outside temp too low which sensor is this or is it a coding problem? 4 zone climate in71 degree shop which registered on front dash screen, A/C has a number of temp sensors, which one is problematic for #8 outside temp?? thanks
A/C intermittant only DTC and problem
- Thread starter atomizer
- Start date
Fault is shown in this scan.
This:
... doesn't strike me as a temperature sensor problem.
-Uwe-
This:
Code:
00898 - Control Circuit A/C compressor
009 - Open or Short to Ground - Intermittent-Uwe-
RCV valve V10 TDI
Can defective RCV Valve give code 00898? Preparing to replace complete compressor with new Nissens ,denmark,, Mileage of 175,000,..... UWE you do not have to respond I see enough about this DTC, but am curious if control module can be eliminated as cause before tackling????
Can defective RCV Valve give code 00898? Preparing to replace complete compressor with new Nissens ,denmark,, Mileage of 175,000,..... UWE you do not have to respond I see enough about this DTC, but am curious if control module can be eliminated as cause before tackling????
Last edited:
No, you cannot eliminate the HVAC module (J301) as a potential cause of the problem strictly with VCDS, i.e. without doing electrical testing, or swapping it out for another module.
-Uwe-