A quick run down to what happened.
Rear left corner kept dropping, suspected air leak.
Drenched suspect unit in bubbles, no leak detected.
Removed complete strut and submerged in water. ..still no bubbles.
Suspected solenoid on back of compressor was faulty and air draining back through system so drained air from system by removing pipes from solenoid block
Gave solenoid a little squirt of wd40 in case valves were sticking internally (don't know if I should have done this).
Went to inflate system. Wouldn't raise and red running gear fault on MFA.
Purchased vcds from ross-tech.
Was resetting heights. Got through steps 1-4 entering new heights. Went to save new heights in step 5.
Came up with communications error and didn't save heights and wiped out the original settings
Now I can't enter anything as can't delete fault code of no initial settings learned.
Any help is massively appreciated as currently the motor is parked up down on its bump stops and I need it as it's my daily
Thanks
Gary
Rear left corner kept dropping, suspected air leak.
Drenched suspect unit in bubbles, no leak detected.
Removed complete strut and submerged in water. ..still no bubbles.
Suspected solenoid on back of compressor was faulty and air draining back through system so drained air from system by removing pipes from solenoid block
Gave solenoid a little squirt of wd40 in case valves were sticking internally (don't know if I should have done this).
Went to inflate system. Wouldn't raise and red running gear fault on MFA.
Purchased vcds from ross-tech.
Was resetting heights. Got through steps 1-4 entering new heights. Went to save new heights in step 5.
Came up with communications error and didn't save heights and wiped out the original settings
Now I can't enter anything as can't delete fault code of no initial settings learned.
Any help is massively appreciated as currently the motor is parked up down on its bump stops and I need it as it's my daily
Thanks
Gary