Results 1 to 4 of 4

Thread: BETA 17.12.0 - HEX-NET keeps wanting to update firmware

  1. #1
    Verified VCDS User
    Join Date
    Jan 2016
    Location
    Australia
    Posts
    49
    Post Thanks / Like

    BETA 17.12.0 - HEX-NET keeps wanting to update firmware

    Hi,

    I have just updated to the latest Beta 17.12.0. I have a HEX-NET and after upgrading to 17.12.0 I went into "program options/test" to re-register my HEX-NET interface and was instructed that "Status: Firmware update required!". My Hex-net was on 0.4401 so I clicked the update link which launched the VCDS Interface Config V2.242 and it successfully updated to CB: 0.4409/ FW 0.254/ CFB: 0.10/ BL: 0.28. I then closed the update tool and went back to options/test and it shows CB: 0.4409.4 with "Status: Firmware Update Required!". So I am now in this update loop as when I am taken back to the interface config tool it says my HEX-NET is "up to date". My HEX-NET won't work as I cannot save my test as "OK" forces the firmware update process.

    Anyone else seen this issue?

    rgds
    A

  2. #2
    Verified VCDS User PetrolDave's Avatar
    Join Date
    Dec 2014
    Location
    South Molton, UK
    Posts
    1,440
    Post Thanks / Like
    You need to switch your HEX-NET onto the beta channel using the config utility. This has been mentioned a few times on here.

  3. Likes Boki Ar, Eric, Uwe liked this post
  4. #3
    VCDS Distributor Boki Ar's Avatar
    Join Date
    Oct 2014
    Location
    Arandjelovac, Serbia
    Posts
    937
    Post Thanks / Like

  5. Likes Eric, Uwe liked this post
  6. #4
    Verified VCDS User
    Join Date
    Jan 2016
    Location
    Australia
    Posts
    49
    Post Thanks / Like
    cheers. Will do. I suppose I have never had to do this in the past but it makes sense.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •