burnbrae
Active Member
Car starts and then stops, had a load of can faults, checked the gateway as had issues with them before alltho never non starters, found pins broken (main live in and a few others). repaired plug and replaced with a new gateway.
Cant communicate with the gateway and the fans are running as soon as ignition put on. Further wiring issues or lost immobiliser coding??
Cant communicate with the gateway and the fans are running as soon as ignition put on. Further wiring issues or lost immobiliser coding??
Code:
Thursday,07,September,2017,15:30:25:61714
VCDS -- Windows Based VAG/VAS Emulator Running on Windows 7 x86
VCDS Version: 17.8.0.1
Data version: 20170721 DS276.2
www.Ross-Tech.com
Chassis Type: 1K (9M - VW Jetta IV (1998 > 2014))
Scan: 01 02 03 08 09 15 16 17 19 22 29 35 36 37 39 46 47 55 56 57
75 76
VIN: WVWZZZ1KZ8M349808
-------------------------------------------------------------------------------
Address 01: Engine Labels: 03G-906-016-BKC.clb
Part No SW: 03G 906 021 PM HW: 03G 906 021 AN
Component: R4 1,9L EDC G000SG 1136
Revision: --H07--- Serial number: VWX7Z0GN24E0O1
Coding: 0000071
Shop #: WSC 00066 000 00000
VCID: 79F23A993328408ECD-5102
8 Faults Found:
005712 - Powertrain Data Bus
P1650 - 000 - Missing Message from Instrument Cluster
Freeze Frame:
Fault Status: 01100000
Fault Priority: 3
Fault Frequency: 13
Reset counter: 255
Time Indication: 0
Freeze Frame:
RPM: 0 /min
Speed: 0.0 km/h
Load: 0.0 %
Voltage: 11.63 V
Bin. Bits: 11001100
Torque: 0.0 Nm
Torque: 351.4 Nm
005785 - Powertrain Data Bus
P1699 - 000 - Missing Message from Steering Wheel Electronics
Freeze Frame:
Fault Status: 01100000
Fault Priority: 3
Fault Frequency: 13
Reset counter: 255
Time Indication: 0
Freeze Frame:
RPM: 0 /min
Speed: 0.0 km/h
Load: 0.0 %
Voltage: 11.63 V
Bin. Bits: 11001100
Bin. Bits: 00000000
(no units): 0.0
049478 - No Communication with Diagnostic Gateway
U0146 - 000 -
Freeze Frame:
Fault Status: 01100000
Fault Priority: 3
Fault Frequency: 13
Reset counter: 255
Time Indication: 0
Freeze Frame:
RPM: 0 /min
Speed: 0.0 km/h
Load: 0.0 %
Voltage: 11.63 V
Bin. Bits: 11001100
Bin. Bits: 00000000
(no units): 0.0
006272 - Powertrain Data Bus
P1880 - 000 - Missing Message from Diagnostic Gateway
Freeze Frame:
Fault Status: 01100000
Fault Priority: 3
Fault Frequency: 10
Reset counter: 255
Time Indication: 0
Freeze Frame:
RPM: 0 /min
Speed: 0.0 km/h
Load: 0.0 %
Voltage: 11.63 V
Bin. Bits: 11001100
Bin. Bits: 00000000
(no units): 0.0
005785 - Powertrain Data Bus
P1699 - 000 - Missing Message from Steering Wheel Electronics
Freeze Frame:
Fault Status: 01100000
Fault Priority: 3
Fault Frequency: 13
Reset counter: 255
Time Indication: 0
Freeze Frame:
RPM: 0 /min
Speed: 0.0 km/h
Load: 0.0 %
Voltage: 11.63 V
Bin. Bits: 11001100
Bin. Bits: 00000000
(no units): 0.0
005685 - Powertrain Data Bus
P1635 - 000 - Missing Message from A/C Controller
Freeze Frame:
Fault Status: 01100000
Fault Priority: 3
Fault Frequency: 10
Reset counter: 255
Time Indication: 0
Freeze Frame:
RPM: 0 /min
Speed: 0.0 km/h
Load: 0.0 %
Voltage: 11.63 V
Bin. Bits: 11001100
Bin. Bits: 00000000
(no units): 16.0
053273 - Control Module for Instrument Cluster
U1019 - 000 - Missing Signal for Oil Level/Temperature
Freeze Frame:
Fault Status: 01100000
Fault Priority: 3
Fault Frequency: 5
Reset counter: 255
Time Indication: 0
Freeze Frame:
RPM: 0 /min
Speed: 0.0 km/h
Load: 0.0 %
Voltage: 11.63 V
Bin. Bits: 11001100
Bin. Bits: 00000000
(no units): 0.0
005488 - Engine Start Blocked by Immobilizer
P1570 - 000 - - MIL ON
Freeze Frame:
Fault Status: 11110000
Fault Priority: 1
Fault Frequency: 1
Reset counter: 255
Time Indication: 0
Freeze Frame:
RPM: 1008 /min
Speed: 0.0 km/h
Load: 0.0 %
Voltage: 11.70 V
Bin. Bits: 00001100
Bin. Bits: 11000000
(no units): 33.0
Readiness: 0 0 0 0 1
End-------------------------(Elapsed Time: 06:06)--------------------------
Last edited by a moderator:
