Hello!
I just received my Hex-V2 Connector and wanted to give it a go. The problem is that my laptop gives me an error message when I plug it in. The error reads : USB device not recognized, (did not start)Code 10
Now, I've tried the obvious, such as :
I even tried the less obvious,
Honestly I'm beginning to run out of ideas! Anyone had the same problem??
Thanks!
I just received my Hex-V2 Connector and wanted to give it a go. The problem is that my laptop gives me an error message when I plug it in. The error reads : USB device not recognized, (did not start)Code 10
Now, I've tried the obvious, such as :
- Rebooting
- tryied all different ports on my laptop (Dell I7 with windows 10) ,
- re-installing drivers,
- re installings VCDS alltogether.
I even tried the less obvious,
- tinkered with the power consumption option to make sure USB ports are always fully powered,
- uninstalling and re-installing the drivers for my USB ports...
Honestly I'm beginning to run out of ideas! Anyone had the same problem??
Thanks!
Last edited: