Search:

Type: Posts; User: GXCars

Page 1 of 2 1 2

Search: Search took 0.51 seconds.

  1. Replies
    22
    Views
    889

    OK where are u located and would you need the...

    OK where are u located and would you need the whole van or just the ecu and cluster ?

    Thanks

    Ian
  2. Replies
    22
    Views
    889

    Gerrards Cross

    Gerrards Cross
  3. Replies
    22
    Views
    889

    So as everyone suspected the car has had an immo...

    So as everyone suspected the car has had an immo bypass done on the ECU, the key is not matched to the cluster and try as I might with 3 different tools I canít seem to retrieve the SKC I think is...
  4. Replies
    22
    Views
    889

    So in answer to that question here in Europe its...

    So in answer to that question here in Europe its a bit of a scam, what happens is stuff is shipped from China as a bulk consignment full of thousands of orders usually shipments are 7-8000 kgs each !...
  5. Thread: Boot wont open

    by GXCars
    Replies
    22
    Views
    718

    If it was just a bumper they wouldnt have put the...

    If it was just a bumper they wouldnt have put the car in the oven just the bumper, ovens dont usually melt wiring they normally go up to 60oc which is the same as hot bath water.

    If the tailgate...
  6. Replies
    22
    Views
    889

    I'd love to send it to you Jack but I tink the...

    I'd love to send it to you Jack but I tink the cost would be prohibitive even though I work in the airfreight business part time here in the UK!
  7. Replies
    22
    Views
    889

    They key has a transponder in it but thereís no...

    They key has a transponder in it but thereís no way I can tell if itís been previously used, the issue I have now is that I canít pull the SKC because I donít have a ďworkingĒ key which is required...
  8. Replies
    22
    Views
    889

    Ill get a couple of new immo chips and take it to...

    Ill get a couple of new immo chips and take it to someone who has Geko then and get them to reload everything properly, I dont suppose you can disable the immo in the can gateway to stop the light -...
  9. Thread: Boot wont open

    by GXCars
    Replies
    22
    Views
    718

    Lookimg at the fault codes and the history I...

    Lookimg at the fault codes and the history I would guess the lock is faulty, take it back to the bodyshop and have them put a new lock in it, what happened with ours was that the lock got stressed...
  10. Replies
    22
    Views
    889

    that is a possibility but how can u tell from the...

    that is a possibility but how can u tell from the scan if thats the case and how can I then disable the light on the cluster as I cant see how to code it out, at this stage I just want the light out...
  11. Thread: Boot wont open

    by GXCars
    Replies
    22
    Views
    718

    I had exactly the same issue with one of my old...

    I had exactly the same issue with one of my old audis after a rear end bump, it was the boot lock itself, the circuit board giot cracked in the accident, new lock and was good as new, try also...
  12. Replies
    22
    Views
    889

    Caddy Flashing Immo Light

    Hi

    Hopefully someone may have seen this before but I'm a little perplexed by this one as it doesnt make sense

    Picked up a 2006 caddy last week as a fixer upper, starts and runs OK when I got it...
  13. Replies
    11
    Views
    263

    We finally resolved this, after removing the CECM...

    We finally resolved this, after removing the CECM to test the wiring the circuits tested OK but the CANBUS appears to turn off the circuit immediately it senses there is a bulb failure .

    Therefore...
  14. Replies
    11
    Views
    263

    done some further tests this evening and looking...

    done some further tests this evening and looking at the measuring blocks it show the front indicators energise for about a second using both the stalk and the hazard switch and then stop and a fault...
  15. Replies
    11
    Views
    263

    Yes faults for both indicators come straight back...

    Yes faults for both indicators come straight back up, this is why I was trying to see if there was a test routine as I'm pretty sure its electronic and not electrical
  16. Replies
    11
    Views
    263

    They may be labelled but TBH I was just being...

    They may be labelled but TBH I was just being lazy as I'm not connected to the car and you cant look up the options unless you are physically connected, the wiring diagrams arent the best and the...
  17. Replies
    11
    Views
    263

    Thanks Jack - I'll have to find the wiring...

    Thanks Jack - I'll have to find the wiring diagram as my ELSAWIN isnt working ATM, any idea which MVB it is or I'll have to have a play around later
  18. Replies
    11
    Views
    263

    Thanks for the reply That was my initial...

    Thanks for the reply

    That was my initial thought but as its both sides and I have no hazards or turn signal on the front and the rest of the headlamp works fine im trying to ascertain if its the...
  19. Replies
    11
    Views
    263

    Caddy Front Indicators Not Working

    I have a caddy 2K that has no indicators/turn signals on the front working either one the stalk or on the hazard switch, there is no output at the headlamp assembly and Iíve swapped bulb holders and...
  20. Thread: MFD Issue

    by GXCars
    Replies
    9
    Views
    484

    Thanks for everyoneís help so far, Iíve tried...

    Thanks for everyoneís help so far, Iíve tried those channels Uwe suggested but it just says not available, unless I need some security access to change them?

    I also tried turning off the phone...
  21. Thread: MFD Issue

    by GXCars
    Replies
    9
    Views
    484

    Apologies for the delay - here is the auto scan ...

    Apologies for the delay - here is the auto scan

    Now I have an 02 sensor code - funnily enough after the car was recalled to have another one changed grrr

    what ive noticed is that the issue only...
  22. Thread: MFD Issue

    by GXCars
    Replies
    9
    Views
    484

    MFD Issue

    I have a 2014 Golf 7 GTD with discover pro and the MFD is starting to irritate me, the issue is that I prefer to have the digital speed in the MFD but if the phone rings the display then goes to...
  23. Replies
    16
    Views
    1,111

    Hi Chris There is another thread relating to a...

    Hi Chris

    There is another thread relating to a Golf on here if you google it that seemed to explain the process, seems you need to leave the ignition on for a minute after doing the basic settings...
  24. Replies
    16
    Views
    1,111

    Hi Chris Acording to ELSA G505...

    Hi Chris

    Acording to ELSA

    G505 Differential pressure sensor - says it must be adapted using diagnostics if being changed

    G38 Lambda Sensor on the top of the DPF

    G495 Temperature sender...
  25. Replies
    16
    Views
    1,111

    You may be right Chris I quickly looked at the...

    You may be right Chris I quickly looked at the DPF diagram and it looked like a post DPF sensor but may be a temp sensor

    I’ll have a look in Elsa later to see if there is a better diagram
Results 1 to 25 of 43
Page 1 of 2 1 2