Search:

Type: Posts; User: MartinsX

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Get WD, load test each of wires from APP sensor...

    Get WD, load test each of wires from APP sensor to ECU. Have seen a lot of P1639 fault codes and no bad APP sensors at this age TDI/SDI engines. Always wiring. Newer CR TDI and gas engines is another...
  2. Thanks, golfi_vend, will wait for some news from...

    Thanks, golfi_vend, will wait for some news from You. Have located used ABS module, will have it handy for testing next week. BTW AQ module production is cancelled, it is superseded by BM already in...
  3. There are couple TPI's for gasoline engines,...

    There are couple TPI's for gasoline engines, according those TPI's the ECU FW update should solve the problem. Can't find TDI related similar TPI.
  4. 2014 Passat B7 CFFB DTC 2650/U0415 without any other DTC

    Glow plug light is flashing, CCS does not work, this is the only one DTC. After clearing it comes back after restarting ignition. Car is stock, without any modifications, how far I know. Any ideas...
  5. Replies
    3
    Views
    126

    AT or MT? With MT it's very simple. Ignition...

    AT or MT?
    With MT it's very simple. Ignition switch-wires-connectors-starter - all components of circuit under question.
    With AT starter interlock relay is playing his role in circuit, too.
  6. Implausible signal is the worst DTC description...

    Implausible signal is the worst DTC description to diagnose. It could be not only electrical but mechanical fault, too. For example implausibility between engine rpm value received via CAN and rpm...
  7. Or incorrect level sensors with different rod...

    Or incorrect level sensors with different rod length or bent brackets.
  8. Replies
    8
    Views
    272

    If at this time Your engine starts and runs ok,...

    If at this time Your engine starts and runs ok, and no fault code for missing permission from immo, but there is no address 17 IPC nor address 25 IMMO showing up in autoscan...
    P.S. Since You are...
  9. Replies
    8
    Views
    272

    Your ECU is programmed immo-off or immo emulator...

    Your ECU is programmed immo-off or immo emulator is installed. So You don't need to worry about matching Your replacement IPC.
  10. Replies
    10
    Views
    512

    I agree with Uwe. If reading and analyzing DTC...

    I agree with Uwe. If reading and analyzing DTC and FF data carefully - they are self-explaining.

    1 Fault Found:
    1048835 - Functionality limited due to Engine Control Module
    P1719 00...
  11. Replies
    8
    Views
    272

    Some early A4's had separate immo box, but in MY...

    Some early A4's had separate immo box, but in MY 2000 it should be integrated in IPC.
    Post an autoscan from car in it's current state.
  12. For 60 pin connector: 000979030E small ones,...

    For 60 pin connector:
    000979030E small ones, 0,63mm, wire 0,5mm2
    000979246E big ones, 1,5mm, wire 1,5mm2

    For 94 pin connector:
    000979030E small ones, 0,63mm, wire 0,5mm2
    000979166E small ones,...
  13. Replies
    13
    Views
    748

    I would say ESP warning light comes on because...

    I would say ESP warning light comes on because ESP module receives via CAN that ECU has fault code stored. And fault code in ECU is stored because one of those two:
    Address 61: Battery Regul. ...
  14. Replies
    10
    Views
    403

    I suggest to start with ECU flashing to standard...

    I suggest to start with ECU flashing to standard and up to date FW. The best way is to do it at dealer. Then drive a couple of days and post scan here.
    There definitely something is wrong with this...
  15. Have You flashed NAR ECU with EU file or vice...

    Have You flashed NAR ECU with EU file or vice versa?
  16. Replies
    13
    Views
    748

    As we have no fault codes directly connected to...

    As we have no fault codes directly connected to ESP, do all the steps exactly as I described.
    Did those symptoms were present with original IPC, too?
  17. Replies
    13
    Views
    748

    How often does the ESP light came on? Clear all...

    How often does the ESP light came on?
    Clear all fault codes in all modules, cycle ignition and make a new scan,
    then drive some km and make another scan,
    then drive until ESP light come on and...
  18. Replies
    7
    Views
    394

    I suspect this fault in module 46 is what module...

    I suspect this fault in module 46 is what module 08 is worried about:

    00218 - Humidity Sensor (G355)
    004 - No Signal/Communication
    Freeze Frame:
    ...
  19. NO!!! You have different partnumber clusters....

    NO!!!
    You have different partnumber clusters. Even the same partnumber clusters may have different HW/SW versions and different EEPROM chips in some cases.
  20. Yes, just replace figures in coding string and...

    Yes, just replace figures in coding string and hit SAVE.

    I don't mean that You did some EEPROM changes, but Your tool could do this without notifying You. I had to repair some bricked clusters...
  21. You can try set the coding of replacement cluster...

    You can try set the coding of replacement cluster 1:1 as Your original have and then try replacement procedure via channel 050. Worth a try.
    I haven't experienced any problems with replacing immo 3...
  22. Probably in Germany some more advanced diesel...

    Probably in Germany some more advanced diesel emission testing is used for yearly MOT or whatever is the name of official yearly inspection of vehicle (or the same things called in different names?)...
  23. If original and replacement clusters have the...

    If original and replacement clusters have the same part numbers, then just copy all coding from original and type in the replacement. It is suggested to go through adaptation channels too, as some...
  24. OK. When did You notice too much smoke? Before...

    OK. When did You notice too much smoke? Before all those engine related repairs or after? What was K figure in last emission test, that You did not pass? And in previous one? Is Your EGR electrically...
  25. Don't get off the way! 00550 fault code in ECU...

    Don't get off the way!
    00550 fault code in ECU is primary, 18265 is just consequence.
    If You are completely sure timing is correct, then advance/retard regulator in the HPFP is faulty. Or sticking.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4