Search:

Type: Posts; User: DrPeter

Page 1 of 20 1 2 3 4

Search: Search took 0.04 seconds.

  1. Hello, 00311 - Tire Filling Connection 007...

    Hello,


    00311 - Tire Filling Connection
    007 - Short to Ground - Intermittent


    The fault code above means the [J197-Adaptive suspension control unit] sees a shorted wire to ground to the...
  2. Here is a picture of the Ride Height and Damper...

    Here is a picture of the Ride Height and Damper setting buttons ...

    https://i.imgur.com/JyJKBGg.jpg

    drpeter
  3. Hello, Right, the fault code [01575-Control...

    Hello,

    Right, the fault code [01575-Control Switched Off] when found in the [34-Level Control] controller is an indication the Level Control system is in "Jack-Mode".
    Not to be confused with...
  4. Replies
    3,424
    Views
    1,177,791

    I saw this today had to laugh a little, because I...

    I saw this today had to laugh a little, because I have been there and had to do what I had to do.. :)

    https://i.imgur.com/DtUyyWW.jpg

    But I have been dirtier, especially with the marine...
  5. Hello, Exactly how have you tried to perform...

    Hello,

    Exactly how have you tried to perform the System Function Test?

    Also during these Basic Settings, you will want the engine running and the charging system functioning correctly.

    Hope...
  6. Replies
    6
    Views
    153

    Hello, a.) CAN-Bus messages from other...

    Hello,



    a.) CAN-Bus messages from other controllers
    b.) Strong RF signals / interference / EMF / quasar emissions / etc..
    c.) Faulty controller
  7. Hi again, try a lower or higher value, to see if...

    Hi again, try a lower or higher value, to see if a different value can be saved. Also let us know what your measured value is and what values could and could not be saved.

    Thanks,

    drpeter
  8. Replies
    7
    Views
    188

    Hello, I think the first step is to establish...

    Hello,

    I think the first step is to establish communication to the ECM's and verify they are online and communicating to the other controllers. In order for a control module to communicate, it...
  9. Replies
    10
    Views
    335

    Hi there, I bought a 2009 Passat with the CCTS...

    Hi there, I bought a 2009 Passat with the CCTS engine from the auction, vehicle was in perfect condition, except the writing on the windshield, "ENGINE LOCKED". I basically knew it would need an...
  10. Hello, When you are trying to raise or...

    Hello,



    When you are trying to raise or lower the stock ride height, there is a limit (set by the controller) as to how far you can go.

    The controller may accept each value (chn.01 to 04)...
  11. Hello, Just in case you do not have the ABS...

    Hello,

    Just in case you do not have the ABS coding, based on the VIN should it should be as follows:


    C54BC0F5492800FDA30C03EC92220042271000

    We have a Ross-Tech forum post that explains...
  12. Replies
    5
    Views
    144

    Hello, If you have about 7 minutes, this...

    Hello,

    If you have about 7 minutes, this Ross-Tech video will help :)

    Battery Coding

    If you are having trouble, please post up a complete vehicle Auto-Scan.

    Hope this helps,
  13. Replies
    4
    Views
    123

    Hello, It looks like the ABS controller was...

    Hello,

    It looks like the ABS controller was replaced with an incorrect part. The original part number, based on the VIN should be [1K0 907 379 AE] (drops to a [1K0 907 375 AP] - as per...
  14. Replies
    2
    Views
    85

    Hello, There is a really good website that...

    Hello,



    There is a really good website that can help with PR-Codes, called www.PartsLink24.com, you will need to pay for access, but the information available. Also in Polski :)

    Is there a...
  15. Replies
    1
    Views
    44

    Hello, I hate to say it but this vehicle will...

    Hello,

    I hate to say it but this vehicle will need to connect with Audi using ODIS for the fault code below:

    38144 - No End-of-Line Programming
    B2013 00 [009] - -
    [keine...
  16. Hi there, Posting a complete vehicle Auto-Scan...

    Hi there,

    Posting a complete vehicle Auto-Scan would be helpful :)

    "DPF Carbon Mass: 108.0 (max value 60gr)"

    I think this (above) says it all..... almost double the "max value"? - with the...
  17. Replies
    8
    Views
    474

    Hello, These Advanced Measuring Values...

    Hello,



    These Advanced Measuring Values maybe helpful:

    Charge pressure actuator: actual position
    Charge pressure actuator: specified position

    Charge air pressure control valve position:...
  18. Replies
    11
    Views
    260

    Hello, Thanks for posting up the Auto-Scan! ...

    Hello,

    Thanks for posting up the Auto-Scan!





    Just to help other's out, the fault code listed on the Ross-Tech wiki page, 00526 - Brake Light Switch (F), suggests to Check Measuring Value...
  19. Replies
    10
    Views
    216

    Hello, I had the same thought, missing...

    Hello,



    I had the same thought, missing fuses, etc... You know, you maybe better off having this person put the vehicle back the way he found it. Lights and all! this could be as simple as a...
  20. Hi, just to add ... You may want to: - Cycle...

    Hi, just to add ...

    You may want to:
    - Cycle the ignition off for a ~20 seconds, then back on and start the vehicle.
    - Clear faults from the [34-Level Control] controller.
    - Then back out and...
  21. Hello, That could get expensive! At least...

    Hello,



    That could get expensive! At least you have the right scan tool ;).

    Do you have any Factory Repair Manuals / Wiring Diagrams? They are a must when trying to diagnose these...
  22. Replies
    8
    Views
    474

    Hello, Posting a complete Auto-Scan...

    Hello,

    Posting a complete Auto-Scan would be a good start, this way we can see the details of the vehicle.

    Also Data logging is a good way to help other 'see' certain information during a road...
  23. Replies
    2
    Views
    113

    Hello, We have a Ross-Tech forum thread here...

    Hello,

    We have a Ross-Tech forum thread here, the vehicle had a P174D fault code, there is a decent discussion going on in that thread that may help.

    Also, the K1 and K2 friction plates are...
  24. Replies
    11
    Views
    347

    Hello Steve, The [02E] transmissions...

    Hello Steve,

    The [02E] transmissions were not always the best, many did have drivability issues, including hesitations, juddering, delays when pulling away, etc...

    There have been several...
  25. Hello, Could you post up an Auto-Scan...

    Hello,

    Could you post up an Auto-Scan and what you see in the Measuring Value Block group [032]?

    Also you can run a Basic Settings test, group [107] and let us know what the results are too,...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4