Search:

Type: Posts; User: krisnordal

Search: Search took 0.01 seconds.

  1. found the problem. I had vacuum through the...

    found the problem.
    I had vacuum through the solenoid before. but when I removed the solenoid from the bracket I discovered the issue. Someone (not me) had broken the nipple off the solenoid and...
  2. Replies
    8
    Views
    263

    wher do I get the manual?

    wher do I get the manual?
  3. Replies
    8
    Views
    263

    So if I put vacuum on the intake side of the...

    So if I put vacuum on the intake side of the hockey puck it should open the valve and allow gasses from the valve cover pass into the intake manifold. what about the breather valve? how do you test...
  4. without vacuum, there is no air. if I put vacuum...

    without vacuum, there is no air. if I put vacuum on it opens the valve and the air passes into the exhaust.
  5. so using compressed air I can blow off two rubber...

    so using compressed air I can blow off two rubber gloves fitted over the tail pipes. I connected the combi vale and the SAI and turned it on and that also blew the rubber gloves off the tail pipes. ...
  6. Replies
    8
    Views
    263

    could it be due to a bad pcv? there is a lot of...

    could it be due to a bad pcv? there is a lot of oil going to the intercoolers but I do not know how much is too much.

    I put a liter in the last oil change before that oil change it did not use...
  7. yes there was no build up just carbon...

    yes there was no build up just carbon discoloration
  8. https://photos.app.goo.gl/ouu8XfGvPoah5Etg7

    https://photos.app.goo.gl/ouu8XfGvPoah5Etg7
  9. Thank you that did the trick...

    Thank you that did the trick
    https://photos.app.goo.gl/ouu8XfGvPoah5Etg7

    there does not seem to be that much build up in the passageways. I did verify that the kombi valve is working as it...
  10. not yet it looks like someone stripped the allen...

    not yet it looks like someone stripped the allen key bolt so now I have to get creative as to how to remove it :-(
  11. So the pump is fine. the pulsing was the ECM...

    So the pump is fine. the pulsing was the ECM cycling the relay just turn on and off.
    The pump puts out alot of air the vacuum line to the combi is good, combi holds vacuum, air gets to the combi...
  12. i used vcds to cycle through all the outputs and...

    i used vcds to cycle through all the outputs and all the relays work and when it came to the air pump I sent the signal but it did I as described a flow of air that peaks then dies down and then...
  13. I got a chance to look at it again. and removed...

    I got a chance to look at it again. and removed the SAI pump. when I send a signal to turn it on it pulses. Is this normal? there is a reasonable amount of air coming out of the pump while it is...
  14. Sorry for the Noob question but what is a combi...

    Sorry for the Noob question but what is a combi selenoid? Is it the PCV?
  15. Replies
    8
    Views
    263

    PS the engine in an audi crate engine with 30k on...

    PS the engine in an audi crate engine with 30k on it and when I remove the oil filler cap there is a fair amount of back pressure. I did not install the crate engine but bought it that way.
  16. Replies
    8
    Views
    263

    Oil in the intake tube

    I think I have blown turbo.
    Is there a way to check?

    The inevitable - where is good turbo replacement kit and are there good turbo upgrade kits?
  17. I have number of codes here some I think I know what is wrong others I do not.

    VIN: TRUWT28N031000517 Mileage: 118670km-73738miles
    -------------------------------------------------------------------------------
    Address 01: Engine Labels: None
    Part No: 8N0 906 018...
Results 1 to 17 of 17