Search:

Type: Posts; User: DrPeter

Page 1 of 20 1 2 3 4

Search: Search took 0.05 seconds.

  1. Thread: AC fault codes

    by DrPeter
    Replies
    6
    Views
    109

    Thanks for the Auto-Scan... After you fix the...

    Thanks for the Auto-Scan...

    After you fix the "High Pressure Sensor" fault clear all the DTCs and hopefully the " no signal/communication" faults will clear too.

    And. . . do let us all know...
  2. How to charge a dead battery on a Bentley GT, when the rear lid will not open.

    Hello,

    I made a short video a while ago and I have been wanting to make it public to help people with a common concern on the 2004+ Bentley Continental GT and the Flying Spur.

    Many of these...
  3. Replies
    5
    Views
    202

    Hello, drpeter is in the house.. ;) So......

    Hello,

    drpeter is in the house.. ;)

    So... I would be careful when listening to the Audi dealerships and I do not mean to be disrespectful, however....

    Being an ex-dealer tech (both Audi...
  4. Thread: AC fault codes

    by DrPeter
    Replies
    6
    Views
    109

    Hello, Yes, The fault code in the...

    Hello,



    Yes, The fault code in the Auto-HVAC controller says it all! There is a concern with the G65-Refrigerant Pressure Sensor, it's wiring or connections or perhaps the J255-HVAC Controller....
  5. Replies
    6
    Views
    292

    Hi, I have seen some dealerships charge as much...

    Hi, I have seen some dealerships charge as much as 40 hours for this type of work. It really depends on what you find the vehicle needs. There maybe labor times on the erWin Bentley Motors, I do not...
  6. Replies
    6
    Views
    292

    Hello, You may need to drop the...

    Hello,

    You may need to drop the engine/transmission. If the vacuum lines behind the engine/on top of the transmission have never been replaced, this could be a source for vacuum leaks.

    When...
  7. Replies
    3,404
    Views
    1,150,794

    Hi, hope everyone is doing well... Do not know if...

    Hi, hope everyone is doing well... Do not know if this was posted here before.. perhaps an old one, but still makes me laugh..

    https://i.imgur.com/ImudEBM.jpg


    Have a good Friday/weekend!
    ...
  8. Replies
    2
    Views
    133

    Hello, The H12 is actually an electronic...

    Hello,

    The H12 is actually an electronic siren, not a simple horn (3 wire vs. 2 wire). Typically on the A3's it is located in the rear area of the front right wheel housing.

    You can perform...
  9. Replies
    8
    Views
    159

    I concur with Ntech, the J104-ABS Controller...

    I concur with Ntech, the J104-ABS Controller coding should be [0003365] with the base engine [T74].

    drpeter
  10. Thread: Valvelift GTI

    by DrPeter
    Replies
    1
    Views
    85

    Hello, That is a long shot! :) - Can it be...

    Hello,

    That is a long shot! :) - Can it be done.... sure... Given enough time and resources... you could do it.

    Audi valvelift system (AVS) is not simply added on to a Volkswagen by coding...
  11. Replies
    25
    Views
    749

    Hello, You know, we have a Ross-Tech wiki page...

    Hello,

    You know, we have a Ross-Tech wiki page for the ABS fault code 02214 - Tire Pressure Warning and it mentions the "System Rest" or also known as the "Tire Pressure Monitoring System (TPMS)...
  12. Replies
    2
    Views
    126

    Hello, I agree with PetrolDave. :) - You...

    Hello,

    I agree with PetrolDave. :) - You should verify what Audi says and I may take it a step further if you did not find anything obvious. You may have to loosen and re-torque ALL the suspension...
  13. Replies
    1
    Views
    95

    Hello, Based on some research, it would...

    Hello,

    Based on some research, it would appear the ABS Coding should be [0019073].

    After the Coding is accepted, check and clear codes, it maybe necessary to perform the Basic Settings, see...
  14. Hello, I would check the timing chain...

    Hello,

    I would check the timing chain tensioner. There is a plastic cover on the timing chain cover/case that can be removed to inspect the position of the adjuster.

    This is my 2.0L with...
  15. Replies
    2
    Views
    137

    Hello, If you have not already done so, have...

    Hello,

    If you have not already done so, have a look at the Measuring Value Block (MVB) group [001] for the Compressor Shut-Off Code.
    VCDS will display the numerical value that the J255-Climatic...
  16. Replies
    2
    Views
    168

    Hello, The best $35 ever spent with Audi ... ...

    Hello,

    The best $35 ever spent with Audi ... Official Factory Repair Information

    You can have 24 hour access, complete wiring diagrams, component locations, repair manuals, body repair, TSBs...
  17. Replies
    1
    Views
    122

    Hello, Personally, I have not seen a "fuel...

    Hello,

    Personally, I have not seen a "fuel manifold" fail on a BLV-3.6l engine. I have seen the brass "pressure limiting valve" [03C 103 363 H] fail and cause fuel rail pressure concerns. That...
  18. Replies
    1
    Views
    129

    Hello, The coding of the [09-Cent. Elect.]...

    Hello,

    The coding of the [09-Cent. Elect.] (J519) does not appear to be able to code out the reverse lights functions. The expected coding for this vehicle's (J519) seems to be [20003]. The...
  19. Hello, Here is an easy way to tell if you...

    Hello,

    Here is an easy way to tell if you have an "Immobilizer 4 - Adaptation" or an "Immobilizer 4 - Challenge system".


    Address 25: Immobilizer Labels: 1K0-920-xxx-25.clb
    Part No...
  20. Replies
    9
    Views
    323

    Hello, Interesting.... Glad the coding was...

    Hello,

    Interesting.... Glad the coding was accepted. You actually should consider upgrading to a newer Ross-Tech interface because....

    [New feature! Extended UDS fault detail is only supported...
  21. Thread: AUDI A8 2015

    by DrPeter
    Replies
    2
    Views
    154

    Hello, - Sounds like you may want to check...

    Hello,



    - Sounds like you may want to check the N80-Canister Purge Valve and make sure you do not have raw fuel or too much fuel vapor entering into the intake manifold causing a...
  22. Replies
    9
    Views
    323

    Hello, If the above does not work, please try...

    Hello,

    If the above does not work, please try the following ABS Coding:

    2EAA6B7DD4990BB089920B6781976974D62BD091D081963602415054828812

    If the coding is accepted, you will need to perform the...
  23. Replies
    5
    Views
    230

    Hello, I would strongly recommend to fix these...

    Hello,

    I would strongly recommend to fix these vehicles correctly and not try to modify or code out anything that has to do with safety or performance, the Lamborghini Aventador is a precision...
  24. Hello, Do not change the coding for the...

    Hello,

    Do not change the coding for the [14-Susp. Elect.], it is correct at [000012] since this is a 2008 Audi TT (8J) Coupe with a 3.2l VR6.

    To clear the code 01794-Control Module - Incorrect...
  25. Hello, Actually based on my calculations,...

    Hello,



    Actually based on my calculations, your vehicle was driven 62,973 miles and 922 days have passed since the "TDI diesel emissions modification".

    You can view this information here:...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4