Search:

Type: Posts; User: siLc

Page 1 of 20 1 2 3 4

Search: Search took 0.05 seconds.

  1. Changing the ABS is anyway a rabbit hole in this...

    Changing the ABS is anyway a rabbit hole in this case. Why did you use brakes from the older PQ platform RS3 8P when theres a MQB platform RS3 8V in existence? You could get the ABS off the latter...
  2. Replies
    4
    Views
    220

    I can think of one reason - showing off while...

    I can think of one reason - showing off while stationary :)

    I'd think a tuner can help with this. If memory serves, not any random back alley tuner can handle the ECU of this vehicle but ABT in...
  3. Replies
    31
    Views
    1,850

    Then buy the single repair wire at the dealer and...

    Then buy the single repair wire at the dealer and be done with it ;)
  4. You didn't find anything on bildelsbasen.se ? ...

    You didn't find anything on bildelsbasen.se ?

    Have a look -> http://bildelsbasen.se/se-sv/OEM/1J1959801D/
  5. Replies
    3
    Views
    179

    What do you want to achieve?

    What do you want to achieve?
  6. Replies
    7
    Views
    277

    If a trailer-related fuse was blown, you replaced...

    If a trailer-related fuse was blown, you replaced it, cleared the fault in module 69 and the fault didn't come back - then you should be good. I wouldn't worry about the voltage thing unless after...
  7. Replies
    4
    Views
    233

    I can't understand the "its faulty, don't need...

    I can't understand the "its faulty, don't need it, remove it" mentality on systems which can be easily fixed. The parking buzzer is a very common VW/Audi part 8E0 919 279, which can be had for a...
  8. Replies
    13
    Views
    544

    Bad wiring? Highly unlikely because everything...

    Bad wiring? Highly unlikely because everything else is working (is it?).

    I see your 680B has a SW version of 0245. The latest SW is 0252. You could try updating to that. I had a 680B with this SW...
  9. The AFS master module's factory location is on...

    The AFS master module's factory location is on the right side of the center console, under the dashboard at the same level with the radio. If you remove the glovebox, you'll gain access to it.

    In...
  10. The xenon headlights have AFS slave modules and...

    The xenon headlights have AFS slave modules and you'll need the AFS master 5M0907357E or F.

    A rear levelling sensor is a sensing unit on the rear axle which detects how much the car is loaded with...
  11. Replies
    13
    Views
    544

    The VW flashfiles information repository doesn't...

    The VW flashfiles information repository doesn't apparently list a direct flash for this cluster and anyway, this is something you can't do with VCDS.

    On a side note: If you'd like to get OPS...
  12. Replies
    2
    Views
    167

    Radio part number reveals this is a RCD300 with...

    Radio part number reveals this is a RCD300 with black buttons? Yeah, this is not going to work. You can't get direct AUX-in and instead will have to use a AUX-in converter (CD changer emulator). A...
  13. Replies
    8
    Views
    358

    Open module 08, have a look at measurement blocks...

    Open module 08, have a look at measurement blocks for left and right side temperature flaps V158 and V159. Change the temperature through its range and see how the measurement blocks change - if it's...
  14. Replies
    5
    Views
    252

    If you really want the Mk7 Climatronic panel...

    If you really want the Mk7 Climatronic panel knurled rotary knobs, you can get them by using the proper module for your PQ car - a 1K8907044 module with appropriate suffix out of a Tiguan, Scirocco...
  15. Replies
    8
    Views
    789

    Don't have a sticker like this? This is the data...

    Don't have a sticker like this? This is the data sheet mentioned.

    https://www.vwgenuineparts.co.uk/images/header_445-800.jpg
  16. Replies
    8
    Views
    789

    No need to pay until there are free VW PR code...

    No need to pay until there are free VW PR code decoders such as this http://igorweb.org/equidec.aspx

    Write the three-letter codes from the vehicle's data sheet into it as instructed. Vehicle's...
  17. Replies
    17
    Views
    564

    OP, did you check Sound settings in radio? If...

    OP, did you check Sound settings in radio?

    If amp is present, its located directly under the driver's seat under a plastic cover.
  18. Replies
    17
    Views
    564

    Start with the simple things - check Balance and...

    Start with the simple things - check Balance and Fader menus in Sound menu in radio ;)
  19. On a VW PQ platform vehicle, removing the battery...

    On a VW PQ platform vehicle, removing the battery is pretty much inevitable when the trans has to come out - the battery tray is sitting on the trans side mount.
  20. Thread: Door issue

    by siLc
    Replies
    7
    Views
    283

    Model year 2015 vehicle - I wouldn't call it that...

    Model year 2015 vehicle - I wouldn't call it that old to be already weary of wiring loom troubles in the door loom boot between the chassis and door.

    There's the fault but does it have any real...
  21. Replies
    3
    Views
    181

    By APS you mean "automatic parking sensors"? This...

    By APS you mean "automatic parking sensors"? This is usually known as PLA ("park-lenkung assist" in German).

    On the A3 8V the retrofit of PLA from 8K PDC should be pretty straightforward. Install...
  22. Besides the different AFS modules on the lights...

    Besides the different AFS modules on the lights themselves and the addition of DRL power modules, the main AFS module itself is a different part also - 5M0907357F instead of 6R0907357 you currently...
  23. Replies
    5
    Views
    214

    The new PDC module is on another of the car's CAN...

    The new PDC module is on another of the car's CAN networks, which is sepearate from the one the current old module is on. Hence the need to rewire. Fortunately its only 2 wires.

    You would need to...
  24. Replies
    31
    Views
    1,850

    You'll have to run Comfort CAN to the driver's...

    You'll have to run Comfort CAN to the driver's seat anyway to get memory to work. If this seat also has ventilation, the ventilators are LIN submodules of the BCM, so there's wires to run for these...
  25. Replies
    5
    Views
    214

    The old PDC control unit at address 76 doesn't...

    The old PDC control unit at address 76 doesn't support the OPS (Optical Parking System) feature. You would need to replace the module with a newer one and rewire the CAN connection from (IIRC)...
Results 1 to 25 of 495
Page 1 of 20 1 2 3 4