Search:

Type: Posts; User: Jef

Page 1 of 20 1 2 3 4

Search: Search took 0.05 seconds.

  1. Maybe this:...

    Maybe this:
    https://forums.ross-tech.com/showthread.php?4224-MQB-(Mk7-Golf)-Steering-Angle-Sensor-(G85)-Calibration-in-44-Steering-Assist&p=144324&viewfull=1#post144324
  2. 75x should the the Load Reduction Relay (J59). ...

    75x should the the Load Reduction Relay (J59). Look on the J519 control module, if you see 2 relays with "460" stamped on them, one is the J59 and the other is J329 for terminal 15. Swap the two...
  3. Is there power to the fuse SD2 when the ignition...

    Is there power to the fuse SD2 when the ignition is on?

    Verify the complete Holy Trinity is to factory design.....

    ABS powers:

    T38/1 4.0 ro/ge
    T38/14 0.5 sw/ge
    T38/15 0.5 ro/bl
    ...
  4. For any given control module to be able to...

    For any given control module to be able to communicate:
    https://i.imgur.com/G8YGwbm.jpg

    It looks like fuse SD2 (right side of dash) goes to both ABS and EPB modules. This fuse is on terminal...
  5. Replies
    3
    Views
    69

    From what I can tell, the G395 for this car would...

    From what I can tell, the G395 for this car would be replacement part number 4H0-959-126-B. What are the wire colors for said item? Have you verified /1 and /3 carry load (light up a test light)?
    ...
  6. Replies
    13
    Views
    252

    You can view remote button data in 46-08-010,...

    You can view remote button data in 46-08-010, second field. You will see 0000 and as you hit the buttons they will flip to 1. Panic would be 0001.
  7. Replies
    5
    Views
    116

    A replacement airbag module may also require...

    A replacement airbag module may also require replacement impact sensors. This was a fun game VW played on the later mk4 gen vehicles... airbag module is replaced and now the 4 factory installed...
  8. Replies
    13
    Views
    252

    MVB 020 shows the last 4 alarm triggers. Set the...

    MVB 020 shows the last 4 alarm triggers. Set the alarm off with something else 4 times, rear door or maybe the hood. Then see if you revert back to right front door.



    I'm not sure I follow...
  9. Replies
    13
    Views
    252

    It is possible. Driver's door latches fail more...

    It is possible. Driver's door latches fail more often since they get cycled more... except for those damn Duke boys!


    Again, possible. But it has been my experance a non working power lock is...
  10. Replies
    3,248
    Views
    1,025,673

    I got a new lawn mower:...

    I got a new lawn mower:
    https://i.imgur.com/qJcmUdZ.png?1

    Part of my yard is a downhill with a slope to the left.

    And less than 3 minutes into mowing my yard, here is where I got it stuck:...
  11. Replies
    3
    Views
    58

    http://wiki.ross-tech.com/wiki/index.php/16791/P04...

    http://wiki.ross-tech.com/wiki/index.php/16791/P0407/001031



    I'm showing 9979 as the most recent firmware for the ECM, so you may want to see about having that sorted out. Of course, still...
  12. Replies
    5
    Views
    115

    223.6 BAR of fuel rail pressure at idle seem a...

    223.6 BAR of fuel rail pressure at idle seem a bit... excessive. And I would expect rail pressure to be maintained when the engine is off, so 0 BAR doesn't seem good as well.... at face value,...
  13. Replies
    5
    Views
    115

    With engine at temp (+80C coolant) and at idle,...

    With engine at temp (+80C coolant) and at idle, go to 01-08-001 and field 3 should show fuel rail pressure, make a note of it. Exit out of the ECM, shut engine off. Now back into 01-08-001 and see...
  14. Replies
    3
    Views
    69

    If no leaks, then I would lean on the suspension...

    If no leaks, then I would lean on the suspension sensors. Unplug them and look for rot. Are the electrical paths between the Level Control Module (J197) and sensors to factory design? I suspect...
  15. https://forums.ross-tech.com/showthread.php?4026-P...

    https://forums.ross-tech.com/showthread.php?4026-Popping-fuses-as-soon-as-you-put-them-in

    Rig up a test light tool like that, pop it in place of the S13 fuse. If you have a short to ground, it...
  16. Short answer, it is a weld point, several wires...

    Short answer, it is a weld point, several wires joined together:

    https://i.imgur.com/tCpdH8x.png
    A very generic example of a weld point, wires joined together.

    The "15a" should be a circuit...
  17. Replies
    15
    Views
    184

    Is it possible the fuse panel F is not to design,...

    Is it possible the fuse panel F is not to design, maybe has some fretting (rot) going on?
  18. Replies
    15
    Views
    184

    If T20g/18 doesn't have power, then there is a...

    If T20g/18 doesn't have power, then there is a failure with the Holy Trinity... thus no communication.

    You state that fuse ST3 SF11 is good, so dig deeper... does that fuse have power on it? ...
  19. Replies
    15
    Views
    184

    Playing with the battery cables should not cause...

    Playing with the battery cables should not cause this.... the left side door modules talk. Pull the right front door panel off, turn ignition on, unplug the door control module, J387.

    T20g/18 =...
  20. Replies
    9
    Views
    133

    With the radio, MVB group 004.4 shows the...

    With the radio, MVB group 004.4 shows the telephone mute status. My guess is the phone cradle is messed up and when you dock a phone, to goes to mute when it shouldn't.

    <Toggle Jack mode = ON>
    ...
  21. Replies
    15
    Views
    184

    For any control module to communicate, you must...

    For any control module to communicate, you must have faith in the Holy Trinity:

    https://i.imgur.com/G8YGwbm.jpg

    It would appear that the right side door module, J387 and J389, use the same...
  22. Replies
    1
    Views
    58

    Moved to Car Repair Support. Please post a full...

    Moved to Car Repair Support. Please post a full Auto-Scan for review and also provide detail(s) of what may of caused the fault code to be flagged in the first place.
  23. Replies
    7
    Views
    193

    Is there any sort of popping noise coming from...

    Is there any sort of popping noise coming from the steering rack when turning steering wheel while parked?
  24. Case Study: B201A - Check Software Version Management

    Original source credit for this goes to TBAx.


    5F Information Electronics has the following DTC:

    1555 - Check Software Version Management
    B201A 00 [009] - -

    Code does not...
  25. Replies
    7
    Views
    193

    I would suspect some one took the steering wheel...

    I would suspect some one took the steering wheel off and then did not put it back on correctly. When the G85 reports 0,0 degrees, you should have a level steering wheel. And from there a proper...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4