Search:

Type: Posts; User: DrPeter

Page 1 of 20 1 2 3 4

Search: Search took 0.06 seconds.

  1. Hi.. The key-on with the engine off.. Sorry about...

    Hi.. The key-on with the engine off.. Sorry about that :)

    drpeter
  2. Hello, It is possible the pump may not...

    Hello,



    It is possible the pump may not run with a fault code, however, I would try to run the test after you have started the vehicle, let idle for a few seconds, then shut off the ignition,...
  3. Hi, Ah, okay ... That was the value in your...

    Hi, Ah, okay ... That was the value in your freeze frame.
    I was suggesting to have a look at the 'live' pressure, with VCDS in the Advanced Measuring Values. That way you can 'see' the current...
  4. Hello, You can have a look with VCDS in the...

    Hello,

    You can have a look with VCDS in the Advanced Measuring Values for the AdBlue Pump Pressure, it is displayed in [hPa].

    Use the 'word' filter at the top of the pop-up box of the...
  5. Replies
    2
    Views
    92

    Hello, If the G85-Steering Angle Sensor is...

    Hello,

    If the G85-Steering Angle Sensor is loosing 30-power intermittently, the fault code [01826] is stored and the ESP/TCS warning is displayed.

    As long as the ABS wheel speed sensors are...
  6. Hello, 00311 - Tire Filling Connection 007...

    Hello,


    00311 - Tire Filling Connection
    007 - Short to Ground - Intermittent


    The fault code above means the [J197-Adaptive suspension control unit] sees a shorted wire to ground to the...
  7. Here is a picture of the Ride Height and Damper...

    Here is a picture of the Ride Height and Damper setting buttons ...

    https://i.imgur.com/JyJKBGg.jpg

    drpeter
  8. Hello, Right, the fault code [01575-Control...

    Hello,

    Right, the fault code [01575-Control Switched Off] when found in the [34-Level Control] controller is an indication the Level Control system is in "Jack-Mode".
    Not to be confused with...
  9. Replies
    3,426
    Views
    1,179,315

    I saw this today had to laugh a little, because I...

    I saw this today had to laugh a little, because I have been there and had to do what I had to do.. :)

    https://i.imgur.com/DtUyyWW.jpg

    But I have been dirtier, especially with the marine...
  10. Hello, Exactly how have you tried to perform...

    Hello,

    Exactly how have you tried to perform the System Function Test?

    Also during these Basic Settings, you will want the engine running and the charging system functioning correctly.

    Hope...
  11. Replies
    6
    Views
    162

    Hello, a.) CAN-Bus messages from other...

    Hello,



    a.) CAN-Bus messages from other controllers
    b.) Strong RF signals / interference / EMF / quasar emissions / etc..
    c.) Faulty controller
  12. Hi again, try a lower or higher value, to see if...

    Hi again, try a lower or higher value, to see if a different value can be saved. Also let us know what your measured value is and what values could and could not be saved.

    Thanks,

    drpeter
  13. Replies
    7
    Views
    194

    Hello, I think the first step is to establish...

    Hello,

    I think the first step is to establish communication to the ECM's and verify they are online and communicating to the other controllers. In order for a control module to communicate, it...
  14. Replies
    10
    Views
    402

    Hi there, I bought a 2009 Passat with the CCTS...

    Hi there, I bought a 2009 Passat with the CCTS engine from the auction, vehicle was in perfect condition, except the writing on the windshield, "ENGINE LOCKED". I basically knew it would need an...
  15. Hello, When you are trying to raise or...

    Hello,



    When you are trying to raise or lower the stock ride height, there is a limit (set by the controller) as to how far you can go.

    The controller may accept each value (chn.01 to 04)...
  16. Hello, Just in case you do not have the ABS...

    Hello,

    Just in case you do not have the ABS coding, based on the VIN should it should be as follows:


    C54BC0F5492800FDA30C03EC92220042271000

    We have a Ross-Tech forum post that explains...
  17. Replies
    5
    Views
    154

    Hello, If you have about 7 minutes, this...

    Hello,

    If you have about 7 minutes, this Ross-Tech video will help :)

    Battery Coding

    If you are having trouble, please post up a complete vehicle Auto-Scan.

    Hope this helps,
  18. Replies
    4
    Views
    130

    Hello, It looks like the ABS controller was...

    Hello,

    It looks like the ABS controller was replaced with an incorrect part. The original part number, based on the VIN should be [1K0 907 379 AE] (drops to a [1K0 907 375 AP] - as per...
  19. Replies
    2
    Views
    88

    Hello, There is a really good website that...

    Hello,



    There is a really good website that can help with PR-Codes, called www.PartsLink24.com, you will need to pay for access, but the information available. Also in Polski :)

    Is there a...
  20. Replies
    1
    Views
    46

    Hello, I hate to say it but this vehicle will...

    Hello,

    I hate to say it but this vehicle will need to connect with Audi using ODIS for the fault code below:

    38144 - No End-of-Line Programming
    B2013 00 [009] - -
    [keine...
  21. Hi there, Posting a complete vehicle Auto-Scan...

    Hi there,

    Posting a complete vehicle Auto-Scan would be helpful :)

    "DPF Carbon Mass: 108.0 (max value 60gr)"

    I think this (above) says it all..... almost double the "max value"? - with the...
  22. Replies
    8
    Views
    513

    Hello, These Advanced Measuring Values...

    Hello,



    These Advanced Measuring Values maybe helpful:

    Charge pressure actuator: actual position
    Charge pressure actuator: specified position

    Charge air pressure control valve position:...
  23. Replies
    11
    Views
    269

    Hello, Thanks for posting up the Auto-Scan! ...

    Hello,

    Thanks for posting up the Auto-Scan!





    Just to help other's out, the fault code listed on the Ross-Tech wiki page, 00526 - Brake Light Switch (F), suggests to Check Measuring Value...
  24. Replies
    10
    Views
    232

    Hello, I had the same thought, missing...

    Hello,



    I had the same thought, missing fuses, etc... You know, you maybe better off having this person put the vehicle back the way he found it. Lights and all! this could be as simple as a...
  25. Hi, just to add ... You may want to: - Cycle...

    Hi, just to add ...

    You may want to:
    - Cycle the ignition off for a ~20 seconds, then back on and start the vehicle.
    - Clear faults from the [34-Level Control] controller.
    - Then back out and...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4