Search:

Type: Posts; User: Gremling

Page 1 of 4 1 2 3 4

Search: Search took 0.02 seconds.

  1. Thread: Battery drain

    by Gremling
    Replies
    9
    Views
    163

    That is by far to low, but need to be measured...

    That is by far to low, but need to be measured under load (or with a better tester), one can also check the acid (std lead accumulator batteries). A good battery shall have 12,75VDC or more, should...
  2. Thread: Dpf issues

    by Gremling
    Replies
    19
    Views
    482

    Last oil-, oilfilter and air filter change? ...

    Last oil-, oilfilter and air filter change?

    Regards
    Gremling
  3. Nah, have my own solution now. Extender chord...

    Nah, have my own solution now.
    Extender chord between OEM headlight cable and headlight, cut cable for Xenon curtain function, and this circuit/current/voltage is feed via a small low control signal...
  4. Replies
    7
    Views
    500

    Tried this? ...

    Tried this?

    https://www.myturbodiesel.com/wiki/door-open-chime-disable-diy-with-vcds-2010-vw/

    or this
    https://www.audiworld.com/how-tos/a/audi-q5-how-to-disable-door-open-chime-422113

    quite...
  5. Thread: Dpf issues

    by Gremling
    Replies
    19
    Views
    482

    Hi, with regards to low turbo pressure. The way...

    Hi,
    with regards to low turbo pressure. The way I read scan, the engine (ECU) wants 2.65bar, it gets 2,36, a difference in 0,3bars, hmmm.
    (Hectopascal / 1000 = bar -> hectopascal = millibars).
    ...
  6. Try to disconnect cables/penetrator from...

    Try to disconnect cables/penetrator from alternator, clear fault codes and perform scan. There has been some issues where diode brigde in alternator fails, and this drags down/short the 12VDC. Check...
  7. Replies
    7
    Views
    165

    Hi, you most likely have this file, but I...

    Hi, you most likely have this file, but I recommend Audi SSP 243, this is Audi training program regarding air suspension for the Allroad link: http://www.volkspage.net/technik/ssp/ssp/SSP_243.pdf
    ...
  8. Replies
    16
    Views
    505

    Yes HMC, have tried it, I filled in km and time...

    Yes HMC, have tried it, I filled in km and time from last service to actual km and days, filled oil quality to good etc. It is only in this specific car this has been a problem. As stated earlier,...
  9. Replies
    16
    Views
    505

    WillCo, can do this when I get back home again...

    WillCo, can do this when I get back home again (just went offshore, back in 14-15days). Do you want this done, even if my friend gets this initialized from VAG dealer?

    Regards
    Gremling
  10. Replies
    16
    Views
    505

    Just went offshore, will do so when back home...

    Just went offshore, will do so when back home (14-15days or so). Want it even if the module has been initialized?

    Regards
    Gremling
  11. Replies
    16
    Views
    505

    Tried, all the above, no luck, drives car a few...

    Tried, all the above, no luck, drives car a few km and spanner shows up again.

    Seems like a module will not take/handle commands properly. When using VCDS and
    In control module 17 i see:
    Oil...
  12. Replies
    16
    Views
    505

    Have tried all above tip for SRI reset, no...

    Have tried all above tip for SRI reset, no difference, car is driven for a few km, and maintenance spanner comes up again (alternating spanner and gear indicated).
    S this has been tested, but no...
  13. Replies
    14
    Views
    251

    OK, Know you have a different heater than I have,...

    OK, Know you have a different heater than I have, but just wanted to check. Might be worth buying the test equipment, prior to buying a new main board, this test will also show if fault is car side...
  14. Replies
    14
    Views
    251

    Any chance You could have incorrectly connected...

    Any chance You could have incorrectly connected one of the the outer 2 2pins plug, or one of the 2 big 2 pins plug or 3 smaller 2pins plug?

    Exapmle of parts/equipment needed for Webasto test via...
  15. Replies
    14
    Views
    251

    Where are you located, the temp sensor reads...

    Where are you located, the temp sensor reads -40deg and -50deg C. Does this make any sence?
    The voltage in initial fault code is/was way to high, have this been deleted? Has it come back if deleted?...
  16. Replies
    14
    Views
    251

    Hi, Try to connect the VCDS to your car, select...

    Hi,
    Try to connect the VCDS to your car, select aux heater controller, and then select measure blocs, from here find and monitor voltage to and in heater, this will be a live stream.
    ...
  17. Replies
    16
    Views
    505

    Its a 2011 1,6 tdi (although VIN has the C as...

    Its a 2011 1,6 tdi (although VIN has the C as 10th digit -> 2012.

    Have tried to, in the following order, and with test run in between:
    Reset SRI with Hexnet-V2 (VCDS), software version 19.6.0.6...
  18. Replies
    16
    Views
    505

    Unable to perform SRI

    Hi, Gremling here,
    Last evening I tried to help out a friend with his VW Jetta, 2011 1,6 tdi, it had just been to service at a Toyota dealer/workshop ( we do not have a VAG dealer within a few...
  19. Replies
    9
    Views
    357

    Just to close thread, and sorry for not doing so...

    Just to close thread, and sorry for not doing so earlier.
    001037 - EGR Temperature Sensor 1
    P040D - 000 - Signal too High - MIL ON

    Replaced the temp sensor -G98- between EGR...
  20. Replies
    2
    Views
    154

    Do not know, we just bought the car yesterday, on...

    Do not know, we just bought the car yesterday, on our way home (a 1300km tour). I will check wiring loomb when we get home. I know the car was originally sold in Hermany, and imported to Norway 2015....
  21. Replies
    2
    Views
    154

    Audi A5 ABS control module

    Hi, I am unable o clear faultcode on my sons newly bought 2011 A5 2.0 TFSI
    Car has had the famous engine upgrade/repair, a few years ago at an Audi workshop in Germany, seller did not mention any...
  22. Replies
    4
    Views
    292

    Thanks for the reply folks, in acc to schematics,...

    Thanks for the reply folks, in acc to schematics, it seems like its wirered thru 1 fuse, and not switchable
    Will investigate in the winter, when cold and shitty outside :-)

    Regards
    Gremling
  23. Replies
    4
    Views
    292

    Audi A6 Allroad 4F cigarette socket

    Hi, is it possible to reprogram the function for the cigarette socket to only be powered when ignition is set to on, or only when car is running?


    Regards
    Gremling
  24. Replies
    3
    Views
    204

    jupp, still evaluating best option (for him and...

    jupp, still evaluating best option (for him and me), cause heŽll agree to what I suggest, but I am the one having to do it.
  25. Replies
    3
    Views
    204

    2006 Audi A6 Release load on steering

    Hi, got a call from father in law yesterday, his Audi 2006 A6 2.0tdi would not disengage steering wheel lock, gear shifter or anything else but radio.

    Please be advices that all the following...
Results 1 to 25 of 83
Page 1 of 4 1 2 3 4