Search:

Type: Posts; User: VWT6

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. The set of measurement values is pretty limited...

    The set of measurement values is pretty limited even on Gen5 - understandably just the internals of the AWD. It took me a while to get grab on what was going/not going on. I would have liked to...
  2. I have done some measurements to understand how...

    I have done some measurements to understand how Haldex system works, however it was 5th gen.which means it’s easier to diagnose using VCDS.

    Just a few thoughts of what I learned having VCDS hooked...
  3. As Spacewalker suggests - in the link a tweak to...

    As Spacewalker suggests - in the link a tweak to use maps the other way round for Discovery Media (Europe) --->...
  4. Replies
    10
    Views
    632

    Could use any additional bits of information also...

    Could use any additional bits of information also for

    Address 18: Aux. Heat Labels: None
    Part No: 7E0 815 071 B
    Component: J737__Standheizung 0605
    Revision: 00085000 ...
  5. Thread: Adblue warning.

    by VWT6
    Replies
    5
    Views
    578

    Thanks. Yes indeed the system tries to warm up...

    Thanks. Yes indeed the system tries to warm up the AdBlue at cold temperatures. However, I’m afraid that’s not very successful in my case. Anyways, the main thing is that the freezing won’t cause any...
  6. Thread: Adblue warning.

    by VWT6
    Replies
    5
    Views
    578

    --------------------------------------------------...

    --------------------------------------------------------------------------------
    Auto Scan -->...
  7. More details sent to Support@Ross-Tech.com

    More details sent to Support@Ross-Tech.com
  8. The fix - verified now. Beta 19.1 + CB:0.4502....

    The fix - verified now. Beta 19.1 + CB:0.4502. Thanks again.
  9. I see... let me know if there is something I...

    I see... let me know if there is something I could try. Any use if a VW garage would try the same just to see if their tool can handle this?
    Anyways, at the moment no real need to tweak the heater....
  10. Thank you very much for your prompt response. And...

    Thank you very much for your prompt response. And yes, I do understand the challenge to differentiate the two IDE06625's from each other :D.

    Anyways, still on my wishlist is the capability to log...
  11. Bumping up an old challenge + adding a new...

    Bumping up an old challenge + adding a new strangeness of same module.

    When I tick manually all the measurements as in the picture, I can save the measurement values then into a log file as...
  12. Replies
    21
    Views
    2,839

    Somewhat confused now.:confused: Are you saying...

    Somewhat confused now.:confused: Are you saying that if a function exists in VCDS adaptation menu (e.g. Addr 09, Channel 11 Central Audible Locking) it also means that the functionality actually...
  13. Mika_M, slightly off topic but I think the...

    Mika_M, slightly off topic but I think the Webasto in your friends van currently does not preheat the engine (before starting) with that coding. It works only as cabin heater. To preheat also the...
  14. Thanks for prompt response. Updated the HEX-V2,...

    Thanks for prompt response. Updated the HEX-V2, it's now at 0.4422. The behaviour is still the same :(.

    In addition to the earlier exited from VCDS, turned ignition off, wait, ignition on,...
  15. VW Transporter T6, Address 18 Aux.Heat --- Adaptation FAIL

    Adaptations fail on Module 18, Aux. Heater. (Webasto Thermo Top Evo)

    As per "screenshots" below.

    Module accepts security code 20103 (verified that doesn't accept "wrong" code).
    Tried a few...
  16. Replies
    29
    Views
    9,175

    While you were working on my debug file, I did...

    While you were working on my debug file, I did another run of 30+ minutes using old setup just to gather more data just in case... and noticed two glitches in that run. So it was quite rare event...
  17. Replies
    29
    Views
    9,175

    I did a run. Recorded probably just one glitch at...

    I did a run. Recorded probably just one glitch at time stamp 1232.73 sec in total of more than 160 ksamples - not too bad :) - emailed the debug files to support@ross-tech.com - if...
  18. Replies
    29
    Views
    9,175

    Oops..:confused: Well, just being back on-line...

    Oops..:confused: Well, just being back on-line noticed that there was a firmware update for HEX-V2 (CB: 0.4409.4) which has an improvement related to grouped requests. So, the previous runs were with...
  19. Replies
    29
    Views
    9,175

    Yep. A lot better :). I did three runs, total of...

    Yep. A lot better :). I did three runs, total of 13551 lines each 12 measuring values with same setup as before. I found one (1) glitch similar to what saw before. Unfortunately it was in first run...
  20. Replies
    29
    Views
    9,175

    Thanks again. Unfortunately I won't have a chance...

    Thanks again. Unfortunately I won't have a chance to try before 15th of Dec. I'll report back then.
  21. Replies
    29
    Views
    9,175

    Thanks. Mailed to support@ debug and log files...

    Thanks. Mailed to support@ debug and log files for 2 runs with 1024 debug option on.

    Unfortunately I didn't realize that VCDS concatenated both runs into one debug file - that's why it is huge...
  22. Replies
    29
    Views
    9,175

    Thanks. I replaced vcds.exe with the one from the...

    Thanks. I replaced vcds.exe with the one from the link. I did a run for Haldex, and another for ECU.
    The Haldex is a lot better - no glitches in 30 mins - so it looks good. Groupings 7 and 8 seem to...
  23. Replies
    29
    Views
    9,175

    Thanks for prompt response. Sorry about the size...

    Thanks for prompt response. Sorry about the size of debug file but it's the VCDS which records just huge amounts of data!:D That's good news - that they are just glitches, not errors of the module...
  24. Replies
    29
    Views
    9,175

    Downloaded the update 4408, running VCDS beta...

    Downloaded the update 4408, running VCDS beta 17.10.0. Unfortunately I still get glitches and sometimes also sampling slightly slows down. I do hope they are just glitches not real ones.

    Switched...
  25. Replies
    29
    Views
    9,175

    Perhaps same problem, missing samples, corrupted data?

    Hi.
    Am I possibly hitting the same problem, too? At time stamp 3.65 - 12.22. In the file below.
    3.65 14.5 3.65 8 3.65 0 3.65 0 3.65 0 3.76 0 3.76 6.6...
Results 1 to 25 of 32
Page 1 of 2 1 2